A dd a Window Sheet, Foam Adhesive Strips, and sequins to create a Shaker Card!
Project Recipe
Dimensions:
Pacific Point card base: 4 1/4" x 11"
Real Red layer: 4 1/8" x 5 3/8" - need two
Whisper White layer: 4" x 5 1/4" - need two
Real Red for marquee: 3 1/4" x 3 1/2"
Pacific Point for marquee banner: 1 1/4" x 3"
Silver Glimmer for star & sparkles: scrap
Window Sheet for shaker: 2" x 2 1/4"
Pacific Point for envelope liner: 2 1/4" x 5 5/8"
Adhere Real Red layers to card front and inside with SNAIL.
Emboss one white layer with Lucky Stars folder.
Adhere to card front with SNAIL.
Rub Real Red and Pacific Point with Embossing Buddy.
Stamp marquee on Real Red with Versamark.
Stamp bottom marquee banner on Pacific Point with Versamark.
Sprinkle with white powder. Heat with Heat Tool.
Cut out all of Real Red marquee with Paper Snips.
Cut out the center of marquee.
Stamp "Awesome!" with Versamark on Pacific Point banner. Sprinkle with white powder. Heat with Heat Tool.
Cut out banner with Paper Snips, cutting out the notch for the tip of the arrow.
Add pieces of Tear & Tape Adhesive to the back side of the marquee window opening.
Stamp "YOU ARE" with Staz-on black on the Window Sheet.
Adhere the window sheet to the Tear & Tape. Trim end edges of the window sheet that might extend beyond the edge of the marquee.
Add Foam Adhesive Strips around the window opening but do not remove the top paper strip yet.
Cut Silver Glimmer with smallest Star Framelit. Put star and a few Brights sequins in a pile in the upper center of the white front layer.
Pat the edges of the foam adhesive strip with the Embossing Buddy.
Remove the paper strip from the adhesive strips. Adhere the marquee to the card front over the star/sequins to create the shaker window.
Peel the backing from remainder of Silver Glimmer. Stamp the back side of the Silver Glimmer with one of the sparkle stamps and black ink. Cut out with Paper Snips.
Adhere to Pacific Point banner with SNAIL or a glue dot.
Stamp inside white layer with words and sparkles using black ink.
Add Clear Wink of Stella to the sparkles.
Adhere inside card with SNAIL.
Punch one end of 2 1/4” x 5 5/8”” of DSP with Gift Bag Punch Board, lining up the edge of the paper with the “Start” line on the board before punching. Flip paper end-over-end and line up the opposite side of the paper with the “Start” line before punching again. Adhere inside envelope just below the glue line using a line of SNAIL ONLY along the top edge of the liner. Fold envelope flap down to crease the liner and push it farther down into the envelope. Stamp the envelope to match your card and you are done!