P retty thank you card using new Stampin' Up! products.
Project Recipe
Cut cardstock, designer paper, and Adhesive Sheets pieces to the following sizes using a Paper Trimmer:
- card from Misty Moonlight Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Night of Navy Cardstock
- 3-7/8" x 5-1/8" of blue tile pattern on very pale pink background design from In Good Taste Designer Series Paper
- 1" x 5-1/2" from Misty Moonlight Cardstock
- 7/8" x 5-3/8" from Adhesive Sheets
- 1-3/4" x 2-1/2" from Petal Pink Cardstock
Adhere the piece of In Good Taste Designer Paper to the large Night of Navy rectangle and then to the front of the Misty Moonlight card.
Peel the protective backing off of the Adhesive Sheets rectangle. Adhere the Adhesive Sheets rectangle to one side of the long, skinny Misty Moonlight rectangle. Be sure to leave the other protective backing in place for now.
Pick out the long, skinny, chain of square medallions die from the Many Medallions Dies. Put it on top of the Misty Moonlight rectangle on a platform on your cutting and embossing tool so the Misty Moonlight (blue) side is facing up. Run through the tool. Use the Take Your Pick Die Brush Tip and Take Your Pick to remove the pieces.
Carefully remove the protective backing from the back of the long, skinny, chain of medallions cut out. Adhere the chain of medallions cut out to the front of the card so it is about 1" from the bottom edge and the left and right ends overhang the matted designer paper just a tiny bit.
Mount the "thanks!," "Celebrate," or "Congrats" sentiment from the Many Mates Set on Block G. Ink it up with the Night of Navy Ink Pad. Stamp it in the center of the Petal Pink rectangle.
Pick out the label with pointy ends die from the Tasteful Labels Dies. Put it on top of the stamped sentiment on a platform on your cutting and embossing tool so the sentiment is centered. Run through the tool.
Use Stampin' Dimensionals to adhere the sentiment label cut out to the lower right side of the card so it is centered over the chain of medallions cut out.
Cut a 9" piece of the Misty Moonlight/silver Baker's Twine from the Flowers For Every Season Ribbon Combo Pack.
Tie a small bow in the center of the twine. Trim the ends.
Use a Mini Glue Dot to adhere the twine bow to the card front at a slight angle on the left side of the sentiment label cut out.