ard Cuts - DSP= Designer Series Paper
Card Base-Night of Navy: 5 1/2 x 6 3/4 scored at 4 1/4
Card Stock- Basic White: 4 x 5 1/4 and 1 x 2 1/2
-Night of Navy: 1 1/2x 4 1/4; 1/2 x 3 and 3/4 x 2 1/2
-Basic Gray: 2 3/8 x 5 3/8
-Soft Suede: 4 x 5
-Mossy Meadow: 1 1/2 x 3
Specialty Paper: Silver Foil 1 x 4
DSP- In Good Taste: 2 1/4 x 5 1/4 and (2) 5/8 x 2 1/4
-Using Basic Gray Ink stamp the following onto the Soft Suede: a shovel, shears, broom, gloves, hand shovel. (Note: all this have already been done for you) You will need to stamp the ladder onto the small piece of Soft Suede in your packet. Set Aside.
-Using Night of Navy ink stamp the "Happy Father's Day" sentiment onto the 1 x 2 1/2 Basic White piece. Set aside.
-Also stamp the "Thanks for Helping Me Grow "Sentiment onto the top left corner of the 4 x 5 1/4 Basic White piece.
- Using the Garden Dies cut out the ladder from the stamped soft suede piece.
-Using the same dies cut out a large shovel head, small shovel head and the blades for the shears.
-Using the Stitched Rectangle dies cut out the sentiment.
(Note: all the other stamped pieces have already been die cut out for you)
-Using the Delightful Tag Topper punch out a topper from both sides of the 1 1/2 x 4 1/4 Night of Navy ink.
-then cut in half. Set Aside.
-Adhere one of the punched Night of navy pieces onto the front flap about 1 5/8" from top edge.
- Adhere the Basic Gray pieces to the front flap.
-Adhere the DSP onto the Basic Gray on the front flap.
- Adhere the Stitched sentiment label to the Night of Navy 3/4 x 2 1/2 piece then add them both to the front of the front flap about 3/8" from top edge.
-Adhere two of the grass die cuts to the bottom of the front flap then using Dimensionals add the ladder to the left side of the front flap just above the grass.
-Apply the stars as desired.
Inside of flap:
-Adhere the other Basic Gray pieces to the inside front flap.
-Adhere the DSP onto the Basic Gray on the inside front flap.
-Adhere the 5/8 x 2 1/4 DSP strips on the inside of the front flap one about 3/8" from top edge and one about 3/8" from bottom edge.
-Adhere the small blue hooks onto the top DSP strip one on each end.
-Adhere the Silver Foil pieces to the both the large and small shovels and the shears. Then add the large shovel to one of the hooks and the shears to the other hook.
-Adhere the broom at an angle on the bottom of the inside flap.
Inside right side:
-Score the other punched Night of Navy piece about 3/4" down from hole. Then adhere it to the inside right of the card about 1 5/8" from top edge.
-Adhere the 4 x 5 1/4 Basic White piece to the right side of inside of card.
-Add two of the grass die cuts, small hand shovel and gloves to the lower right hand corner.
Tie a ribbon through both tag topper pieces to close the card.