G reat card for encouraging someone through a rough time. Uses Stampin' Up! products.
Project Recipe
Cut card stock and designer paper pieces to the following sizes using a Stampin' Trimmer:
- card from Dapper Denim Card Stock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from tiny blue diamonds on vanilla background design of paper from Moroccan Designer Series Paper
- 3-1/2" square from Dapper Denim Card Stock
- 3-3/8" square from Very Vanilla Card Stock
- 1" x 3" strip from Delightful Dijon Card Stock
Adhere the piece of Moroccan Designer Series Paper to the front of the Dapper Denim card.
Mount the vertically striped, more detailed lighthouse image from the High Tide Photopolymer Set on Block H. Ink it up with the Dapper Denim Ink Pad. Stamp it on the right side of the vanilla square.
Mount the large piece of ground image from the High Tide Photopolymer Set on Block H. Ink it up with the Emerald Envy Ink Pad. Line the stamp up so the notch will fit around the bottom of the stamped lighthouse and stamp. Ink the stamp up again and stamp it again to fill in the rest of the bottom of the vanilla square.
Mount the image of two tufts of sea grass on Block A. Ink it up with the Delightful Dijon Ink Pad. Stamp on the left side of the vanilla square on top of the green ground cover. Ink it up again and stamp to the right of the lighthouse just above the green ground cover.
Mount the sentiment of your choice on Block C. Ink it up with the Delightful Dijon Ink Pad. Stamp it just to the left of the lighthouse above the ground cover.
Mount the ray of light image on Block H. Ink it up with the Delightful Dijon Ink Pad. Stamp off on your work paper. Then, stamp it so it looks like the thin edge is coming out of the top of the lighthouse.
Mount the flying birds image on Block H. Ink up only the 3 biggest birds using the Dapper Denim Ink Pad. Stamp them to the left of the lighthouse at the top of the vanilla square.
Adhere the stamped vanilla square to the Dapper Denim square.
Slide one short edge of the Delightful Dijon strip into the open Banner Triple Punch. Punch.
Adhere the punched strip to the back of the matted vanilla/blue square so it is centered behind the ray of light and the notched edge sticks out to the left about 1-1/4".
Adhere the punched strip/matted layer to the card front.
Remove one star Urban Underground Embellishment from the protective backing and adhere it to the center of the punched strip.