B irthday Card using the Friendly Hello stamp set and the matching DSP Friendly Hello.
Project Recipe
Thick White Cardstock 5 1/2” x 8 1/2”
Score at 4 1/4”
Petal Pink Cardstock 5 3/8 x 4 1/8”, 3/4” x 2 3/4”
DSP 4” x 5 1/4”
White Cardstock 5/8” x 2 1/2”
Stampin’ Blends:
Petal Pink
Just Jade
Daffodil Delight
Balmy Blue
Crumb Cake
Ink Pad:
Tuxedo Black Memento Ink Pad
Scraps of Basic White Cardstock to stamp the Bird and Flowers.
Glue the DSP to the Petal Pink layer then glue to card front.
Using Stampin’ Seal run a line across lower center edge of DSP. Attach a layer of 5” long White Frayed Ribbon. But before you attach it fray each end a little bit. Then adhere to the Stampin’ Seal strip.
Stamp the bird and flowers and using he Stampin’ Blends color them according to the picture I have provided.
Fussy cut them all out.
Place dimensionals under the bird, and one dimensionals under the larger flower at the right side and a Mini Glue dot under the left flower. Attach the large flower to the left over the ribbon at an angle.
Place the bird over that but just above the flower petals.
The 2 single flowers are not on dimensionals.
Glue one flower over the leaf of the bird branch.
Stamp the sentiment on the 2 1/2” x 5/8” Basic White Cardstock and cut the left side at an angle, and then glue to the 3/4” x 2 3/4” Petal Pink Cardstock and cut at an angle on the left to match the sentiment layer.
Glue together and glue to the lower right corner of the card front. Add a flower to the sentiment placing it at the left side.
Add some Wink Of Stella to the bird and flowers.
Add 3 Pearl Basic Jewels to the card.
Inside Card:
DSP 3/4” x 4”. Glue this to the left side keeping a small white border on the left.
Stamp sentiment