N o stamping card using Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer:
- card from Early Espress Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Soft Succulent Cardstock
- 3-7/8" x 5-1/8" of large print brown plaid design from He's The Man 12" x 12" Specialty 12" x 12" Designer Series Paper
Adhere the large rectangle of He's The Man Designer Paper to the center of the Soft Succulent rectangle and then to the front of the Early Espresso card.
Cut a 4" piece of the Soft Succulent 1/2" Satin Shimmer Ribbon so it has a sharp angle on each end.
Put a 2-1/2" piece of Tear & Tape Adhesive horizontally across the lower left corner of the card front about 1" from the bottom and about 3/4" from the left edge.
Remove the protective backing and adhere the ribbon to the Tear & Tape Adhesive as shown.
Carefully punch out the van with surfboard die cut and the "Grand Adventure" sentiment die cut from the sheet of die cuts in the He's The Man 12" x 12" Specialty Designer Series Paper.
Adhere the "Grand Adventure" sentiment die cut to the front of the card so it is centered over the ribbon.
Use Stampin' Dimensionals to adhere the van with surfboard die cut to the front of the card so it is centered over the top of the sentiment die cut and the bottoms of the tires overlap the top of the sentiment die cut just a tiny bit.
Use the mini spatula on the Take Your Pick to carefully peel up 1 large bronze dot from the sheet of Brushed Metallic Dots making sure that you get the adhesive backing as well. Adhere it to the upper right corner of the card front so it is centered over crossed lines..