T
his card was made primarily using the Designer Series Paper in the Hues of Happiness Suite and the coordinating dies.
Card Cuts - DSP = Designer Series Paper!
Card Base - Coastal Cabana - 5 1/2 x 8 1/2 Scored at 4 1/4
Card Stock - Gorgeous Grape - 3 x 4
- Basic White - 4 x 5 1/4, 1 x 3 1/4
DSP - Hues of Happiness - 4 x 5 1/4, 2 1/2 x 3 3/4 plus 12 x 12 sheet with flowers and leaves that match up with dies (I cut these out ahead of time)
Project Recipe
Instructions:
Stamping:
Using Black Memento Ink stamp the sentiment onto the 1 x 3 1/4 Basic White piece.
Stamp inside sentiment onto the 4 x 5 1/4 Basic White piece towards the top of the sheet.
Die Cutting:
Using the Happiness Abounds Dies and the long border die with notches cut along the left edge of the 3 x 4 Gorgeous Grape Piece. (Note: You will want to make sure that the cut edge in placed along the outside edge.)
If you have not already done so cut out flowers and leaves from one of the DSP 12 x 12 sheets. (keep all extra pieces in a container for use later)
Assemble:
Adhere the 4 x 5 1/4 DSP piece to the card front.
Adhere the 2 1/2 x 3 3/4 DSP piece to the Gorgeous Grape Card Stock with die cut edge.
Wrap ribbon around bottom edge of both of these pieces then adhere to the card front at an angle as shown. Tie a bow and add to right side of ribbon.
Using Liquid glue adhere two of the die cut leaves one towards the top right and one towards the bottom left of the DSP as shown.
Then Using Dimensionals add one of the large flowers that you die cut out. overlapping both leaves as shown.
Using Paper Snips fussy cut around the sentiment that you stamped then with liquid glue add to flower on card front as shown.
Adhere the 4 x 5 1/4 Basic White piece to inside of card. Then adhere one of the small flowers you die cut earlier to the bottom right hand corner.
See how easy it is to put together a card made primarily with Designer Series Paper with coordinating Dies. Super Fun and they always look like you put so much effort into making them!