Hand-Penned Petals #5 Flip Flop Fold

{ tams # 61598 }

Print Recipe

Cardstock Measurements:
Just Jade--5 1/2" x 10 1/2" scored at 4 1/4", 5 1/4" & 6 1/4"
So Saffron--4" x 5 1/4", scrap for sentiment, 1 3/4" x 4" (3)
Highland Heather--2 1/2" x 3 3/4"
Basic White--4" x 5 1/4", 1 1/2" x 3 3/4", 3 1/2" square
Hand-Penned DSP--3 3/4" x 5", 1 1/2" x 3 3/4" (3), 2" x 5 3/4" (for envelope)

Stamp the image with Tuxedo Memento Black on the 3 1/2" square Basic White.
Stamp the sentiment on the small Basic White and the inside panel with Tuxedo Memento Black.
Stamp the greeting on the scrap piece of So Saffron and fuzzy cut and add mini stampin' dimensional.
Stamp the image with Highland Heather, So Saffron and Just Jade. I stamped off (2nd Generation) for a softer look.
Add Clear Wink of Stella to image, die cut then pop up with dimensional.
With Dark So Saffron Stampin' Blends color the ribbon, die in a bow. You will adhere to the base of the flower image with a mini glue dot.

Die cut label die from Highland Heather using Stitched So Sweetly Dies.
Burnish the 5 1/4" score line into a "mountain fold" and 4 1/4" & 6 1/4" score lines into a "valley fold".
Adhere DSP to the So Saffron, add Highland Heather label, flower image and sentiment. Now adhere these layers to the front of the cardbase.
Finally randomly add Pastel Pearls to the front.

Adhere the DSP layers to the So Saffron pieces (3), be careful to only adhere between the scored area. Adhere the top and bottom Flip Flop Panels. Note that the middle section is adhered to the back side of the folded piece between 5 1/4" and 6 1/4" score lines. Also be care that the pieces do not bind when opened.

Adhere the center flip flop panel, per diagram.
Adhere the Basic White to the inside of the card base.

Envelope:
Die the 3" x 5 3/4" piece of DSP down approximately the center. Adhere a piece on the lower front of the envelope and the other piece on the top of the envelope flap.