H alloween Treat Holder
Project Recipe
Cut a 11" x 3" piece of Basic Black card stock. Score the long side at 5" and 6".
Cut a 5" x 3" piece of Basic Black card stock. Score the long side at 1/2, 2, 3, and 4 1/2".
Using the long bannr die, cut a window in the middle section.
Fold in all the score lines so that the 1/2" end tabs are the bottom "legs" and fold into each other. Adhere these to the middle section of the first larger piece of Basic Black card stock.
Place the candy in the hold and fold up the back and front. I used two fun-size Snickers but you could fit 3 100-calorie bars found by the register at Walmart or Walgreens. They are sold individually. This holder will also hold a pack of gum.
Cut a 2 7/8" x 4 7/8" piece of DSP and adhere to the front.
Punch a 1/2" circle in the front and back panel. Tie a piece of ribbon through the hole.
Cut a 4 x 2 Stitched Nested label from Basic Gray card stock.
Punch a black cat.
Die cut a Pumpkin Pie pumpkin.
Cut two pieces of DSP 1 1/4" x 4 1/2" and 3/4" x 4 1/2". Cut the ends at an angle.
Stamp the sentiment in Memento Black on Whisper White card stock and cut out with coordinating die.
Adhere the DSP flat to the label. Adhere the shapes with Dimensionals.
Add an epoxy tombstone and bird.