F un decorated tins using Stampin' Up! products.
Project Recipe
Cut designer paper pieces to the following sizes using a Paper Trimmer:
- 3-1/2" square of one of the Shaded Spruce designs from Classic Christmas 6" x 6" Designer Series Paper
- 2-1/4" x 3-1/2" from Whisper White Cardstock
- 3/4" x 3-3/8" from Whisper White Cardstock
- 1" x 3-1/2" from Garden Green Cardstock
Pick out the largest scalloped circle die from the Layering Circles Dies. Put it on top of the square of Classic Christmas Designer Paper on a platform on your Stampin' Cut & Emboss Machine. Run through the machine.
Use strips of Tear & Tape Adhesive around the edges of the back of the scalloped circle designer paper cut out to adhere it to the center of the lid of the Round Tin.
Unlock the Lovely Labels Pick A Punch. Slide one short edge of the thin Whisper White strip into the right side of the punch (the side of the punch with the flatter label top) as far as it will go. Punch.
As you are ready to stamp using the Gift Wrapped Set, place the cardstock on the Stampin' Pierce Mat. Using the mat will help you get a cleaner image each time you stamp.
Adhere the "A very merry Christmas" sentiment from the Gift Wrapped Set on Block H. Ink it up with the Cherry Cobbler Ink Pad. Stamp the sentiment on the sentiment banner so the punched end of the banner is on the left side and the right edge of the sentiment is close to the end of the banner.
Adhere the stamped, punched sentiment banner to the center of the lid of the Round Tip so the straight edge just goes over the edge of the lid on the right side.
Mount the large bow with lots of stripes image from the Gift Wrapped Set on Block D. Ink it up with the Cherry Cobbler Ink Pad. Stamp it on one end of the large horizontal Whisper White strip. Leave room to punch out the image.
Unlock the Gift Bow Builder Punch. Hold it upside down so you can see the punching area. Slide the stamped bow into the punch and get it centered in the bow punching area. Punch. Leave the punch unlocked.
Use Stampin' Dimensionals and Mini Stampin' Dimensionals to adhere the bow punch out to the top of the tin lid at a slight angle so it covers the punched end of the sentiment banner strip and the left edge of the bow just goes over the left edge of the lid.
Mount the small tag image from the Gift Wrapped Set on Block A. Ink it up with the Shaded Spruce Ink Pad. Stamp it on one end of the vertical Garden Green strip so the top of the tag image is up.
Hold the unlocked Gift Bow Builder Punch upside down so you can see the punching area. Slide the stamped tag image into the punch and get it centered in the tag punching area. Punch.
Mount the small holly leaves image from the Gift Wrapped Set on Block A. Ink it up with the Shaded Spruce Ink Pad. Stamp it inside the punched out tag image at a slight angle near the bottom edge.
Adhere the small punched tag image to the top of the lid so the top of the tag image punch out slides under the center of the bow punch out.
Use the mini spatula on the Take Your Pick to carefully peel up a rhinestone from a sheet of Red Rhinestone Basic Jewels making sure that you get the adhesive backing as well. Adhere it to the small tag punch out where the berry would be on the holly.
Fill the Round Tin with treats and put the lid on.