P retty card featuring retiring Stampin' Up! products.
Cut card stock pieces to the following sizes using a Stampin' Trimmer:
- card from Flirty Flamingo Card Stock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Peekaboo Peach Card Stock
- 2-1/2" x 4-1/2" from Whisper White Card Stock
- scrap of Flirty Flamingo Card Stock
Place Peekaboo Peach rectangle into the Happy Hearts Embossing Folder. Place the folder with the card stock inside on top of a Cutting Pad on your Big Shot Platform at the lowest possible setting. Place another Cutting Pad on top of the folder and run through the Big Shot.
Adhere the dry embossed Peekaboo Peach layer to the front of the Flirty Flamingo card.
Mount the "You're the friend" sentiment from the Friendly Wishes Stamp Set on Block D. Ink it up with the Flirty Flamingo Ink Pad. Stamp it in the center of the white strip.
Pick out the banner framelit from the Banners Framelits that cuts a banner that is 1-7/8" wide. Place the stamped sentiment on a Cutting Pad on top of the Magnetic Platform on your Big Shot. Place the banner framelit on top so the sentiment is centered side to side and is just above the notch at the bottom of the banner. Place another Cutting Pad on top and run through the Big Shot.
Squeeze the lid of the Peekaboo Peach Ink Pad to get a pool of ink in the lid. Open the pad but leave the lid exposed. Gently squeeze the Clear Wink of Stella Glitter Brush to get some of the glittery liquid into the brush. Use the Clear Wink of Stella Glitter Brush to pick up some ink from the puddle in the lid and color in the letters of the word "friend" in the sentiment. Pick up more ink from the pad lid as needed. Remember to stroke the brush in one direction only. If you go back and forth, then the card stock could start to pill and tear. When you are done coloring, scribble the brush back and forth on scratch paper until no more color is coming off. By coloring with the Clear Wink of Stella Glitter Brush, you will get a shimmery, colored image. If you want to avoid getting glitter on the ink pad, wipe off excess ink from the pad lid using a paper towel or tissue.
Adhere a strip of the white dots on Peekaboo Peach background washi tape from the Playful Palette Designer Washi Tape to the top of the stamped banner. Trim off excess washi tape.
Cut a 10" piece of Flirty Flamingo 3/8" Ruched Ribbon. Put SNAIL across the back of the banner. Adhere the ribbon to the back of the banner so it goes back and forth three times.
Put strips of Tear & Tape Adhesive across the back of the banner and over the ribbon. Remove the protective backing and adhere the banner to the left side of the card front about 5/8" from the top and left sides of the Peekaboo Peach layer.
Adhere a Peekaboo Peach heart from the 2016-2018 In Color Enamel Shapes to the heart on the sentiment over the word "friend."
Unlock the Confetti Hearts Border Punch. Slide the scrap of Peekaboo Peach Card Stock into the punch so it is flush against the back edge. Punch.
Pick out one of the larger punched out hearts. Adhere it to the center of one of the embossed hearts on the card front near the bottom right corner of the banner. Use the Fine-Tip Glue Pen to adhere it in place.