S uper simple card using some new In Color products from Stampin' Up!
Project Recipe
Cut card stock and designer series paper pieces to the following sizes using a Stampin' Trimmer:
- card from Berry Burst Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Whisper White Cardstock
- 2-3/4" x 4" of Berry Burst rose clusters on white background design from Fresh Florals Designer Series Paper Stack
Mount sentiment of choice from the Floral Phrases Set on Block B, Block C, or Block H depending on the sentiment you choose. Ink it up with the Berry Burst Ink Pad. Stamp it in the upper right corner of the white rectangle.
Mount the large rose cluster image from the Floral Phrases Set on Block H. Ink it up with the Berry Burst Ink Pad. Stamp it on the left side of the white cardstock so the bottom of the image is about 2-3/4" from the bottom of the cardstock.
Adhere the piece of Fresh Florals Designer Series Paper to the bottom of the stamped white rectangle.
Cut a 5" piece of Berry Burst 1/2" Finely Woven Ribbon.
Lay the ribbon piece across the card front so it hides the seam between the stamped white layer and the designer paper. Flip the card front over and fold the ends of the ribbon over. Adhere them in place with pieces of Tear & Tape Adhesive across the ends.
Remove the protective backings from the Tear & Tape and add more SNAIL Adhesive to the back of the white rectangle. Adhere to the front of the Berry Burst card.
Cut a 4" piece of Berry Burst 1/2" Finely Woven Ribbon. Slide one end under the ribbon already on the card. Tie in a half knot so it is just to the right of the stamped rose cluster. Trim the ends.
Add three Berry Burst Glitter Enamel Dots to the front of the card as shown.