E asy elegance with layered very vanilla and vellum papers creating a background for the layered pine tree.
Project Recipe
Paper cut sizes: Alternate 1
Very Vanilla Base: 4 1/4 x 11, scored at 5 1/2
Gold Panel - 4 x 5 1/4 (I cut the middle out to reuse leaving about an inch frame all around
Very Vanilla - 3 1/2 x 4 3/4
Vellum 3 1/4 x 4 1/2
Very Vanilla 2 3/4 x 3 1/2
2 Very Vanilla Scraps large enough to die cut trees ~ 2 3/4 x 3 1/2
Alternate 2: With
Gold Foil Edged Card as base
Very Vanilla 3 7/8 x 5 1/8
Vellum 3 1/2 x 4 3/4
Very Vanilla 2 3/4 x 3 1/2
2 Very Vanilla Scraps large enough to die cut trees ~ 2 3/4 x 3 1/2
Die cut the two large pine trees from very vanilla. Fluff out the boughs on the smaller tree die cut using a bone folder.
Shake the Champagne Shimmer paint bottle. Open it and use a small paint brush to brush the inside lid to capture a bit of paint. Paint the small outwardly curled boughs on the die cut. Let it dry.
Layer the very vanilla, gold and vellum panels. Glue or adhere in layers using glue dots except for the smallest very vanilla.
Run ribbon around the front of the smallest panel of very vanilla. Adhere to back using Tear n' Tape or glue dots.
Adhere the smaller die cut tree to the larger die cut tree using multi purpose glue or mini dimensionals.
Adhere the tree to the smallest very vanilla panel using dimensionals. Covering the ribbon.
Tie a small piece of ribbon around the ribbon already on the smallest piece of very vanilla. Tie it to the right of the tree. trim ends using an angle cut. Adhere the very vanilla panel to the other layers on the base card.