P retty card perfect for lots of occasions using Stampin' Up! products including some that can be earned for FREE during Sale-A-Bration 2023.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer:
- card from Petal Pink Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Evening Evergreen Cardstock
- 3-7/8" x 5-1/8" of of lines of white hexagons drawn on orange background design from Favored Flowers 12" x 12" Designer Series Paper
- 2" x 3-1/2" from Evening Evergreen Cardstock
- 1-1/2" x 3" from Petal Pink Cardstock
- 1" x 4" from Evening Evergreen Cardstock
- flower and leaves cut from tightly packed pinkish mums and dark green leaves design from Favored Flowers 12" x 12" Designer Series Paper
Adhere the large orange with hexagons Favored Flowers Designer Paper rectangle to the center of the large Evening Evergreen rectangle and then to the front of the Petal Pink card.
Pick out the small rectangle of leafy vines die from the Eden Dies. Put it on top of the 2" x 3-1/2" Evening Evergreen rectangle on a platform on your Stampin' Cut & Emboss Machine. Run through the machine. Use the paper-piercing tool on the Take Your Pick to remove the pieces.
Use Multipurpose Liquid Glue or Fine-Tip Glue Pen to adhere the leafy rectangle cut out to the front of the card so it is 1" from the left side of the card and about 1-1/4" from the bottom of the card.
Pick out the long, skinny label with leafy ends die from the Eden Dies. Put it on top of the Petal Pink strip on a platform on your Stampin' Cut & Emboss Machine so you'll cut out as much of the label as possible. Run through the machine. Use the paper-piercing tool on the Take Your Pick to remove the pieces.
Mount the "sending hugs" sentiment from the Eden's Garden Set on Block B. Carefully ink up ONLY the word "hugs" using the brush tip of the Evening Evergreen Stampin' Write Marker. Breathe on the stamp to moisten the ink. Stamp the word in the center of the leafy label cut out with the leafy end on the left side.
Adhere the stamped sentiment label cut out to the card front so it is centered inside the leafy vine rectangle cut out. Cut off any excess leafy label on the right edge.
If you haven't already done so, cut out a single mum with leaves from the Favored Flowers Designer Paper by hand using the Paper Snips Scissors.
Use Stampin' Dimensionals to adhere the cut out flower and leaves to the front of the card so it covers the right end of the sentiment label cut out and the right side of the leafy vines rectangle cut out.
Pick out the leaf sprig die from the Eden Dies. Put it on top of one end of the thin, remaining Evening Evergreen strip on a platform on your Stampin' Cut & Emboss Machine. Run through the machine. Use the paper-piercing tool on the Take Your Pick to remove the pieces. Repeat on the other end of the strip so you have two leaf sprig cut outs.
Use Multipurpose Liquid Glue or Fine-Tip Glue Pen to adhere the leaf sprig cut outs to the front of the card as shown so they stick out from the top of the flower cut out.
Use the mini spatula on the Take Your Pick to carefully peel up 3 different size butterflies from the sheet of Brushed Brass Butterflies making sure you get the adhesive backings as well. Adhere them to the front of the card front as shown.