L ove someone enough to give them a DSP Shaker Dome Card! This technique can be used with any shaker dome!
Project Recipe
CS=Card Stock
TOMBO= Multipurpose Liquid Adhesive
All dimensions are in inches
DSP=Designer Series Paper (Printed Paper)
DSP Cutting and scoring:
--If directional, please note you will need to have it going up and down along the 5-1/2" way.
--Cut DSP @ 5-1/2 x 12
Scoring DSP:
--Place front side up and score at 3-1/2 (this is your card front) and at 7-3/4
See Picture
See picture for folding instructions.
Cutting and Die Cutting:
Real Red:
--Cut one of the machine base, one of the machine cap.
--Cut one of the detailed machine fronts, the base strip and the skinny little part that goes on the top of the cap and the strip for the base of the cap. NOTE: apply Adhesive Sheets to the back of CS first, die cut, peel off the backing and adhere to the machine base and adhere the small pieces to the cap. (This is all done before assembling Shaker portion.)
--Basic White: Cut 1 inside @ 4 x 5-1/4
Die cut the 3-1/2" wide part of the DSP front where the Shaker dome will go. NOTE: Watch the die cut placement. The skinny part is the top of the "bowl."
Remove the release paper from the front of the shaker dome and put the back of the card front on top and press.
Add Tear & Tape to the back of the card front
Add a few small pinches of the beads to the shaker dome
Peal off all the release papers and bring the other side to the front and adhere. See picture
Finishing the front:
--Put the Silver Brad through the spinner and through the Silver Front and secure.
--Adhere the Silver front to the front of the Real Red machine with dimensionals keeping clear of the brads so it spins freely.
--Using TOMBO, adhere the Real Red Machine parts as shown in the first photo. NOTE: Do not put adhesive on the bottom flap where the "Gumballs" come out....
--Put a pool of liquid adhesive under the flap and put a few balls so they look like they are spilling out of the machine!
--Wrap ribbon around the card base and tie in a knot. I add a rolled up glue dot where the know will be just to hold it in place while tying.
Stamp the inside
--Basic White CS inside: Real Red ink with sentiments of your chosing.
--Stamp the outside of your envelope!