T his is a fun closer card using the envelope punch board.
Project Recipe
Begin with a coastal cabana cardstock cut at 5 1/2" x 8 1/2" scored at 2 1/4" and 6 1/4". Slide one end into the envelope punch board to the guide and punch and then slide the edge to 3" and punch. Do the same thing on the other end on the opposite edge. Then put this into the stampin' trimmer and cut off the ends to form two file folder looks.
Use two pieces of the Retro Fresh DSP cut at 5 1/4" x 2" and repeat the steps in the envelope punch but only go to 2 3/4" instead of 3". Add these to the outside of the card.
On a scrap of very vanilla stamp the greeting and then punch out with the decorative label punch. Cut out a decorative label punch with costal cabana cardstock and then cut in half and add to each side of the vanilla greeting. Add this to the right side of the card using dimensionals.
Stamp 2 of the petite flowers using coastal cabana ink on vanilla card stock and punch with the petite petal punch. Also punch a pansy punch with coastal cabana paper and add one of the petite flowers to the center of this and add with dimensionals to the front of the card on top of the greeting.
Using a coastal cabana piece that is 1/2" x 8 1/2" and wrap this around the card and close with a glue dot and then add the other small flower. Add pearls to finish off the front.
On a piece of vanilla card stock that measures 3 3/4" x 5 1/4", stamp the inside greeting and a small flower in the corner.
On a piece of vanilla card stock that measures 3 3/4" x 5 1/4", stamp the inside greeting and a small flower in the corner.