Project Recipe
Begin with a card base of Tip Top Taupe that measures 4 1/4" x 11" that is scored at 5 1/2", make a faint score line near the center at 7 1/4" and 9 3/4" as a guide for punching the track for the moving card. Insert the word window punch all the way from each side and punch between the two score lines that were made. Along the top of the card, punch 1/2 of a 1 1/4" circle to easily grab the ribbon of the card that will pull out. Adhere a piece of the DSP that measures 4 1/4" x 1 1/4" along the bottom of the card base.
The largest White cardstock is 4 1/4" x 3" and stamp the greeting along the top and if you want some of the footprints in tip top taupe. Add a small piece of ribbon to the largest black (4 1/2" x 3 1/4") using a stapler. Adhered the white to the black piece of cardstock. The smallest white measures 2" x 3" and the RAWR greeting is stamped on this - again, you can add some of the footprints if you want and then adhere this to a 2 1/4 x 3 1/4" piece of basic black and then the medium piece of whisper white measures 3 1/2" x 3" and you will stamp the dinosaur and the birthday greeting along with some of the footprints. Add this to a piece of blac that measures 3 3/4" x 3 1/4".
Punch out 4 - 1/2" circles out of black card stock and add a dimensional to the center of two of them - line the dimensionals up in the track and then adhere the other circle on the opposite side of the track. Beginning on the inside of the card, flip the inside card face down and center along the top of the base and adhere to the small 1/2" circles. Use sticky strip along the sides of the card base and close this shut with the sticky strip. The smallest greeting will be attached to the front of the two circles so as to cover the tracks. Then using dimensionals center over the small piece (being sure to cover it) and adhere to the front.