G reat kid's card using Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a cutting and scoring tool:
- card from Mango Melody Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 3-3/4" x 5" from Pineapple Punch Cardstock
- 3/4" x 5-1/4" of yellow and orange dinosaur footprints on green background design from Dinoroar Designer Series Paper
- 2-1/2" x 2-3/4" from Whisper White Cardstock
- 1" x 3" from Whisper White Cardstock
- 1-1/2" x 2" from Whisper White Cardstock
As you are ready to stamp using the Dino Days Photopolymer Set, place the cardstock on the Stampin' Pierce Mat. Using the mat will help you get a cleaner image each time you stamp. Put some paper (Grid Paper works great) on top of the mat to protect it from ink.
Mount the feathery leaf image from the Dino Days Set on Block B. Ink it up with the Old Olive Ink Pad. Stamp it multiple times in the upper right corner of the Pineapple Punch rectangle. Re-ink every now and then. Let the images overlap and go off the edges.
Adhere the stamped Pineapple Punch layer to the front of the Mango Melody card.
Adhere the strip of Dinoroar Designer Paper across the Pineapple Punch layer about 1” from the bottom of the card. The ends should stick out on either side a bit.
Put the small strip of white cardstock on top of a platform on your cutting and embossing tool. Put the lace die on top so the pointy edges will cut “teeth” in one short side of the white strip. Run through the machine several times. Use the Take Your Pick Die Brush Tip and paper-piercing tool on the Take Your Pick to remove the pieces.
Mount the “You’re Rawrsome!” sentiment from the Dino Days Set on Block B. Ink it up with the Mango Melody Ink Pad. Stamp on the white strip near the “teeth” cut into the right edge.
Mount the t-rex image from the Dino Days Set on Block D. Ink it up with the Old Olive Ink Pad. Stamp it in the center of the larger white rectangle.
Pick out the t-rex die from the Dino Dies. Put it on top of the stamped t-rex image on a platform on your cutting and embossing tool so the t-rex image is centered. Run through the tool.
Put the small rectangle of white cardstock on top of a platform on your cutting and embossing tool. Put the curved spikes die on top. Run through the machine.
Mount the curve of spikes image from the Dino Days Set on Block B. Ink it up with the Pineapple Punch Ink Pad. Stamp onto the spikes cut out so the spikes fit into the spikes.
Put SNAIL along the back of the t-rex cut out along his back and tail curve. Adhere the spikes cut out to the back of the t-rex cut out so they will show.
Use Stampin’ Dimensionals to adhere the t-rex cut out to the left side of the card front so it is centered over the designer paper strip.
Adhere the sentiment cut out to the card front so it is centered over the designer paper strip and the left edge is tucked under the right side of the t-rex cut out.