F un Fold card using Dino Days Suite by Stampin’ Up!®
*Card Back- Pretty Peacock 10.5 x 29cm, score along the 29cm edge at 1.5cm, 5cm, 11cm & 14.5cm
*Front Mat - Pretty Peacock 6.5 x 9.2cm
* Card Front - Pool Party 7 x 14.5cm, score along the 14.5 side at 1.5cm, 5cm
*Back Mat - Pool Party 10 x 14cm
*Whisper White - 6.2 x 8.7cm cut this x 2 (one for card front & other for stamping the Dinosaur)
*Back Panel (to write on) - Whisper White - 10 x 14cm
* Dinoroar Designer Series Paper - 9.7 x 13.7cm
Stamp on the Long Neck Dinosaur in Mango Melody onto one of the small pieces of Whisper White. Then using the matching Dino Dies cut out the Dinosaur image.
With the other small piece of Whisper White cardstock stamp the sentiment onto the left hand corner using Momento Black Ink
Using Old Olive and Pretty Peacock Stamp Pads stamp the smaller back ground images onto the Whisper White.
Fold all the score lines on the Pretty Peacock Card Back and Pool Party Card Front.
** Fold the box to see where the Tear & Tape goes
Card Back- Tape on BACK
Card Front - Tape on FRONT
Adhere Tear & Tape to the 1.5cm tabs close to the score lines on both pieces.
Using Mono Liquid Glue attach the Designer Series Paper to the Pool Party mat. This can then be glued to the Pretty Peacock to form the back of your card.
The stamped Whisper White card front is then adhered to the Pretty Peacock Mat. Then attach this to the Pool Party front.
Pretty Peacock Card Back - remove backing from Tear & Tape. Fold card in half at the 11cm score line (with the DSP on the inside) tucking the 1.5cm tab under and press down. This now should form a box with open sides at the front of your card.
Card Front - add liquid glue to only bottom 6cm (height of box front) and centering it to the front of box.
fold box flat along the 14.5cm fold line and remove tape backing from Card Front tucking tab under adhere to Card Back.
Using dimensionals attach the Dinosaur to the card front and add a couple of Dinoroar Enamel Shapes.
You could add some stamping to the edges of back Panel and adhere to back of the card.