B right and cheery card using some Stampin' Up! products that can be earned for FREE during Sale-A-Bration 2017.
Project Recipe
Cut card stock and glimmer paper pieces to the following sizes using a Stampin' Trimmer:
- card from Daffodil Delight Card Stock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Melon Mambo Card Stock
- 3-7/8" x 5-1/8" from Very Vanilla Card Stock
- 2-1/2" square from Daffodil Delight Card Stock
- 2-1/2" square from Rich Razzleberrry Card Stock
- 2-1/4" square from Bermuda Bay Glimmer Paper Paper in 6"x6" Glimmer Paper Assortment Pack
- 1-3/4" square from Melon Mambo Card Stock
Ink up a Sponge Dauber by rubbing it on the Daffodil Delight Ink Pad. Randomly press the inked up dauber onto the vanilla rectangle multiple times. Be sure to re-ink the dauber each time.
Ink up a different Sponge Dauber by rubbing it on the Melon Mambo Ink Pad. Randomly press the inked up dauber onto the vanilla rectangle multiple times. Be sure to re-ink the dauber each time.
Ink up a different Sponge Dauber by rubbing it on the Bermuda Bay Ink Pad. Randomly press the inked up dauber onto the vanilla rectangle multiple times. Be sure to re-ink the dauber each time.
Ink up a different Sponge Dauber by rubbing it on the Rich Razzleberry Ink Pad. Randomly press the inked up dauber onto the vanilla rectangle multiple times. Be sure to re-ink the dauber each time.
When you are done with your card, you can clean the Sponge Daubers by rinsing them under running water until the water runs clean. Allow them to air dry.
Place the dotted vanilla rectangle into the Large Polka Dot Textured Impressions Embossing Folder. Place the folder with the card stock inside on top of a Cutting Pad on your Big Shot Platform at the lowest possible setting. Place another Cutting Pad on top of the folder and run through the Big Shot.
Adhere the textured, dotted vanilla card stock to the large Melon Mambo rectangle. Then, adhere that to the front of the Daffodil Delight card.
Use the 1-3/4" Circle Punch to punch a circle out of the Bermuda Bay Glimmer Paper.
Use the 1-1/2" Circle Punch to punch a circle out of the Rich Razzleberry square of card stock. Throw away the punched out circle.
Pick out the Stitched Shapes Framelit that cuts out a circle that is 1-7/8" in diameter. Place the Rich Razzleberry square with circle punched out of it on the Cutting Pad on top of your Big Shot Platform on your Big Shot. Place the circle Stitched Shapes Framelit on top so the circle is a little off centered. Place the other Cutting Pad on top and run through the Big Shot.
Pick out the Stitched Shapes Framelit that cuts out a circle that is 1-3/8" in diameter. Place the Melon Mambo square on the Cutting Pad on top of your Big Shot Platform on your Big Shot. Place the circle Stitched Shapes Framelit in the center. Place the other Cutting Pad on top and run through the Big Shot.
Mount the "if you're happy" sentiment from the Designer Tee Stamp Set on Block B. Ink it up with the Rich Razzleberry Ink Pad. Stamp it in the center of the Daffodil Delight square.
Pick out the Stitched Shapes Framelit that cuts out a circle that is 1-7/8" in diameter. Place the Daffodil Delight square with the stamped sentiment on the Cutting Pad on top of your Big Shot Platform on your Big Shot. Place the circle Stitched Shapes Framelit on top so the sentiment is in the center of the circle. Place the other Cutting Pad on top and run through the Big Shot.
Without adhering anything, place the circles on the card front to get an idea of where you want to place them. Make a mental note of where you want the circles to be and then remove them.
Use pieces of Tear & Tape Adhesive to adhere the Glimmer Paper circle to the card front.
Use fine lines of Fine-Tip Glue Pen to adhere the punched out Rich Razzleberry circle where you want it.
Adhere the stamped Daffodil Delight circle in place using SNAIL Adhesive.
Adhere the Melon Mambo circle in place using SNAIL Adhesive.
Add a large circle shape in either Bermuda Bay, Daffodil Delight, or Rich Razzleberry from the Brights Enamel Shapes to the upper right side of the Melon Mambo circle.
Cut a 6" piece of Bermuda Bay Thick Baker's Twine. Tie a small bow. Trim the ends. Adhere the bow to the bottom of the Melon Mambo circle at a slight angle using a Mini Glue Dot.