Project Recipe
Cut Pool Party card stock 5.5 x 8.5, score at 4.25 and fold to make a top fold A2 base card
Cut Tranquil Tide card stock 4 x 5.25 - this will be layer one that you work with, do not attach to card front till you are done
Cut Pool Party card stock 1 x 6
Cut Tranquil Tide card stock 1x6
Cut Coastal Cabana card stock 1.25 x 6
Beginning with Pool Party card stock 1 x 6 piece cut out the zig pattern die from Delicate Lace Edgelits. Keep the top or Zigged edge of the die as close to the top of the strip as possible.
To line up the die and keep it straight I cut a piece of grid paper and put it under and then held the die in place with Washi Tape
Do this with the Coastal Cabana and Bermuda Bay strips as well
Once all three strips are cleaned up they are ready to attach.
Begin with the widest piece which is the Bermuda Bay piece. Attach it to the bottom or open edge of the card front leaving a .25" space at the bottom. Again, use your grid paper to line up everything so it stays straight. The strip will be too long. That's okay, line it up where you want it and once attached trim off the ends.
To attach these strips use Snail on the solid portion and the Zig glue pen to put a dot of glue on the tip of each point
Piece number two is the Bermuda Bay piece. When attaching this one you will turn it so the points face down and line the points up with the piece already attached.
Again put Snail on the solid portion of the piece and Zig glue pen to put a dot of glue on the tip of each point.
Attach and trim off the excess at each end.
Piece number three is the Coastal Cabana piece.
apply Snail to the solid portion and Zig glue pen dots to the tips of each point.
This piece will attach with the points facing up
For the tag punch one each of Tranquil Tide and Coastal Cabana with the Pretty Label Punch
Cut each label in half the long way
Use Snail to layer them leaving a slight edge
Stamp the flower image from Botanical Bliss onto White card stock, punch out this image with the Pretty Label Punch. Be sure to situate the flower so the leaves point down so when you punch it out it looks right.
Color the flower using blender pens. I used Powder Pink, Lovely Lipstick and Tranquil Tide inks for the flower.
Attach the mat label pieces to the back of the white label and attach all to the card front with Stampin' Dimensionals
Use Tranquil Tide ink to add the vine pattern to the bottom of the first layer
Add a few Share What You Love Artisan Pearls and your card is done.