P retty Christmas card using Stampin' Up! products.
Project Recipe
Cut cardstock, designer paper, and cotton paper pieces to the following sizes using a Paper Trimmer:
- card from Soft Succulent Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Evening Evergreen Cardstock
- 3-7/8" x 5-1/8" of small green and gold foil sprigs on white background design from Ever Eden 12" x 12" Specialty Designer Series Paper
- 4" x 5-1/2" of Evening Evergreen cotton paper from Ever Eden 12" x 12" Cotton Paper
- 1-1/2" x 4-1/2" from Soft Succulent Cardstock
- 1-1/4" x 2" of Evening Evergreen cotton paper from Ever Eden 12" x 12" Cotton Paper
Adhere the piece of Ever Eden Specialty Designer Series Paper to the center of the Evening Evergreen rectangle and then to the front of the Soft Succulent card.
Pick out the large, rectangular, leaf wreath die from the Eden Dies. Put it on top of the large Evening Evergreen Cotton Paper rectangle on a platform on your Stampin' Cut & Emboss Machine so the shinier side is face up. Run through the machine a couple of times. Use the Take Your Pick Die Brush Tip and paper-piercing tool on the Take Your Pick to remove the pieces.
Use Multipurpose Liquid Glue or Fine-Tip Glue Pen to adhere the leafy wreath cut out to the front of the card so it is centered.
Pick out the long, skinny label with leafy ends die from the Eden Dies. Put it on top of the Soft Succulent strip on a platform on your Stampin' Cut & Emboss Machine. Run through the machine. Use the Take Your Pick Die Brush Tip and paper-piercing tool on the Take Your Pick to remove the pieces.
Mount the "merry christmas" sentiment from the Christmas To Remember Set on Block H. Ink it up with the Evening Evergreen Ink Pad. Stamp it in the center of the leafy ended label cut out.
Adhere the stamped, leafy ended sentiment label cut out to the front of the card so it is centered inside the wreath cut out.
Pick out the leaf sprig die from the Eden Dies. Put it on top of the small Evening Evergreen Cotton Paper rectangle on a platform on your Stampin' Cut & Emboss Machine so the shinier side is face up. Run through the machine a couple of times. Use the Take Your Pick Die Brush Tip and paper-piercing tool on the Take Your Pick to remove the pieces.
Use Multipurpose Liquid Glue or Fine-Tip Glue Pen to adhere the leaf sprig cut out to the front of the card so it is tucked under the upper left side of the sentiment cut out.
Cut a 3-1/2" piece of the Gold 3/8" Fine Art Ribbon.
Tie a half knot in the center of the ribbon. Trim the ends.
Use a Mini Glue Dot to adhere the ribbon knot at an angle to the front of the card on the lower left side of the sentiment cut out.
Use the mini spatula on the Take Your Pick to carefully peel up 9 rhinestones from a sheet of Red Rhinestone Basic Jewels making sure that you get the adhesive backings as well. Adhere them to the front of the card over some of the small berries on the cotton paper cut outs.