A n interesting Fun Fold card - the Cascading Tri Fold Card using Sale-a-bration products.
Project Recipe
Card base: cut an A4 piece of cardstock to measure 29.7cm x 14.9cm.
Score @ 9.9cm and 19.8cm to create 3 even panels that all measure 9.9cm wide.
Measure 5cm from the bottom of the card stock and cut from the first score line down to the 5cm pencil mark. This will give you your "cascading" card base. Fold the score lines to create the 3 panels.
Contrasting card stock: 9.4cm x 14.4cm - 1 piece
DSP layer: 8.9cm x 13.9cm
Adhere these 2 layers together and attach to card base.
Contrasting card stock: 9.4cm x 14.4cm - 2 pieces.
Pencil mark @ 4.8cm from the top left side on 2 pieces and cut from top right point to pencil mark.
Adhere the single layer of contrasting card stock to inside middle panel of card base for writing on.
DSP layer: 8.9cm x 13.9cm - pencil mark at 4.8cm from top right side and cut from top left point to pencil mark. Adhere the DSP to card stock and attach to the reverse side of the card base, on the same middle panel.
Contrasting card stock: 9.4cm x 9.4cm - 1 piece, pencil mark at 4.8cm from top left side and cut from top right point to pencil mark.
DSP layer: 8.9cm x 8.9cm - 1 piece, pencil mark at 4.8cm from top left side and cut from top right point to pencil mark.
Adhere the DSP to contrasting card stock and then adhere to card base
Stamp the Stippled Rose image onto Basic White card stock using Gray Granite ink. Using a dauber blend a little bit of Calypso Coral ink to the roses. Die cut the rose image out using the dies as well as a die cut leaf.
Die cut a banner from Sylish Shape dies.
Stamp sentiment from Go to Greetings.
Attach dimentionals along the angled card front and attach your die cut rose image so that it sits a little bit over the edge.
Attach your sentiment with dimentionals.
Finish off with some Iridescent Rhinestones.