Project Recipe
Fold your Whisper White cardstock in half and go over to Big Shot station #1. Position the Detailed Santa Thinlits die in the upper top half of your card front. Make sure to leave about half inch on all sides. Run it through the Big Shot using the following "sandwich" from bottom to top:
- Magnetic base plate
- Precision base plate (make sure the black side is facing up)
- cardstock
- thinlit die
- clear plate
Run it through the Big Shot slowly twice to make sure you get a good cut.
When you are done, gently remove the die and then use the die brush to brush the backside of the die to loosen all the tiny pieces. If necessary, use the paper piercing tool at the big shot station to gently poke through the backside - then fully remove the die from your card front and return to your station.
Next, use a few pieces of the tear & tape adhesive along the back side of the Santa image on the outside edges and the brim of his hat. Adhere the red glimmer paper to the backside, facing up.
Finally, place a few dots of glue on the back of your "jolly" die cut and glue in the center on your cardfront, then stamp the "holly" and "wishes" sentiments on either side in Real Red ink.