S imple, fun card using Stampin' Up! products.
Cut card stock and designer paper pieces to the following sizes using a Stampin' Trimmer:
- card from Cucumber Crush Card Stock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" of white flowers on Cucumber Crush background design from 2015-2017 In Color Designer Series Paper Stack
- 3-1/4" square from Cucumber Crush Card Stock
- 3-1/4" square from Whisper White Card Stock
Adhere designer paper to Cucumber Crush card front.
Pick out the stitched circle framelit from the Stitched Shapes Framelits that cuts out a circle that is 2-7/8" diameter. Place the Cucumber Crush square on the Cutting Pad on top of the Platform on the Big Shot. Place the stitched circle framelit on top. Place another Cutting Pad on top and run through the Big Shot.
Mount the small solid tropical leaf image from the Botanical Blooms Set on Block C. Ink it up with the Cucumber Crush Ink Pad. Stamp off onto scratch paper. Then, scratch in the center of the white square.
Mount the veins and dots image on Block C. Ink it up with the Cucumber Crush Ink Pad. Stamp in the center of the leaf.
Pick out the small solid tropical leaf framelit from the Botanical Builder Framelits. Place the stamped leaf on the Cutting Pad on top of the Magnetic Platform on the Big Shot. Place the leaf framelit on top so it is centered over the stamped image. Place another Cutting Pad on top and run through the Big Shot. Keep both pieces of card stock.
Pick out the circle framelit from the Layering Circles Framelits that cuts out a circle that is 2-7/16" in diameter. Place the square with the leaf cut out of it on the Cutting Pad on top of the Magnetic Platform on the Big Shot. Place the circle framelit on top so it is centered over the cut out leaf. Place another Cutting Pad on top and run through the Big Shot.
Without adhering, center the white circle on the Cucumber Crush circle. Put SNAIL on the back of the leaf image and adhere it to the Cucumber Crush circle by fitting it inside the leaf cut out in the white circle.
Adhere the white circle over the leaf so the cut out is centered over the leaf using Stampin' Dimensionals.
Adhere the circles to the card front so they are centered about 1/2" from the top, left, and right sides of the designer paper.
Pull three sequins off of the Gold Sequin Trim. Adhere them as shown using Mini Glue Dots.
Cut a 12" piece of Crushed Curry Baker's Twine. Double it onto itself. Tie a small bow. Trim the ends. Adhere the bow to the bottom of the leaf cut out stem using a Mini Glue Dot.