A nother one of the cards I created for the March RemARKably Creative Blog Tour - Party Animal Suite using Stampin' Up! products.
Project Recipe
Cut card stock and designer paper pieces to the following sizes using a Stampin' Trimmer:
- card from Emerald Envy Card Stock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" of multicolored diagonal stripes on white background from Party Animal Designer Series Paper
- 2" x 5-1/4" of dotted acetate from Fabulous Foil Designer Acetate, you'll be using the silver side
- 1" x 4-1/2" from Pacific Point Card Stock
- 3" square from Crushed Curry Card Stock
- 3" square from Whisper White Card Stock
Adhere the piece of Party Animal Designer Series Paper to the front of the Emerald Envy card.
Put a short line of SNAIL horizontally across the center of the designer paper. Adhere the strip of Fabulous Foil Designer Acetate across the center of the card front. Make sure the silver side is facing up and that you have removed the thin protective film from the one side of the acetate.
Open the Banner Triple Punch and slide one end of the skinny strip of Pacific Point Card Stock into the punch as far as it will go. Punch. Slide the other end into the punch and punch again.
Adhere the punched Pacific Point banner across the center of the foil layer horizontally.
Cut a 4" piece of Emerald Envy 1/8" Taffeta Ribbon. Use a short line of SNAIL horizontally across the center of the Pacific Point banner to adhere the ribbon to the card front.
Pick out the Layering Circles Framelit that will cut out a scalloped circle that is 2-9/16" in diameter. Place the Crushed Curry square on top of a Cutting Pad on your Big Shot Platform. Place the scalloped circle framelit on top. Place another Cutting Pad on top and run it through the Big Shot.
Mount the sentiment on Block D and ink it up with the Emerald Envy Ink Pad. Stamp it in the center of the white square.
Pick out the Layering Circles Framelit that cuts out a smooth circle that is 2-3/8" in diameter. Place the stamped white square on top of a Cutting Pad on the Magnetic Platform on the Big Shot. Place the smooth circle framelit on top so the sentiment is centered side to side and slightly towards the top. Place another Cutting Pad on top and run it through the Big Shot.
Adhere the sentiment circle to the center of the scalloped yellow circle.
Adhere the circles to the center of the card front.
Pick out one of the party hat charms from the Party Animal Embellishments.
Cut an 8" piece of Crushed Curry Baker's Twine. Thread one end of the twine through the top of the party hat charm. Tie a small bow. Trim the ends of the twine.
Adhere the bow and charm to the right side of the sentiment near the end of the "u" in the word "you" using a Mini Glue Dot.
Adhere three of the Emerald Envy star shapes from the 2016-2018 In Color Enamel Shapes randomly to the card front.