P retty thank you card using one of the sets you can earn for FREE from Stampin' Up! during Sale-A-Bration 2017.
Project Recipe
Cut card stock and designer paper pieces to the following sizes using a Stampin' Trimmer:
- card from Sweet Sugarplum Card Stock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 3-3/8" x 4-5/8" from Rich Razzleberry Card Stock
- 3-1/8" x 4-3/8" from Whisper White Card Stock
- 1" x 5-1/2" of purple and pink flowers on white background design of paper from Blooms & Bliss Designer Series Paper
- 1-3/4" x 4" from Whisper White Card Stock
Adhere the strip of Blooms & Bliss Designer Series Paper across the bottom of the front of the Sweet Sugarplum card so it is about 1" from the bottom edge.
Mount "thanks for joining us" sentiment from All Things Thanks Stamp Set on Block C. Use the brush tip of the Sweet Sugarplum Marker to ink up only the word "thanks." Stamp it in the upper right corner of the white rectangle.
Mount the single solid flower image from the Avant Garden Photopolymer Set on Block B. Ink it up with the Blushing Bride Ink Pad. Stamp it randomly down the left side and across the bottom of the white rectangle. Leave a little room between blooms. Remember to re-ink the stamp each time. Leave the stamp on the block without cleaning it.
Re-ink the stamp again with the Blushing Bride Ink Pad. Stamp it once on the small strip of white card stock. Rotate the stamp slightly and stamp it again over the first image. Clean the stamp with the Stampin' Mist and Stampin' Scrub, but leave it on the block.
Ink the stamp up again using the Sweet Sugarplum Ink Pad this time. Stamp it repeatedly down the left side and across the bottom in between the lighter colored flowers. Leave the stamp on the block without cleaning it.
Re-ink the stamp again with the Sweet Sugarplum Ink Pad. Stamp it once on the small strip of white card stock beside the lighter flower. Rotate the stamp slightly and stamp it again over the first image. Clean the stamp with the Stampin' Mist and Stampin' Scrub and put it away.
Mount the flower center image from the Avant Garden Set on Block A. Ink it up with the Sweet Sugarplum Ink Pad. Stamp it in the center of all the Blushing Bride flowers on both pieces of white card stock. Remember to re-ink it each time. Do not clean the stamp and leave it on the block.
Re-ink the flower center image one more time with the Sweet Sugarplum Ink Pad. Stamp it on the end of the word "thanks." Clean the stamp, but leave it on the block.
Ink up the flower center image again, this time with the Rich Razzleberry Ink Pad. Stamp it in the center of all the Sweet Sugarplum flowers on both pieces of white card stock. Remember to re-ink it each time. Clean the stamp and put it away.
Mount the single solid leaf image from the Avant Garden Set on Block A. Ink it up with the Sahara Sand Ink Pad. Stamp it about 3 times along the edge of the flowers near the upper left and lower right. Remember to re-ink each time.
Mount the spray of leaves image from the Avant Garden Set on Block A. Ink it up with the Sahara Sand Ink Pad. Stamp it twice near the middle of the bank of flowers. Remember to re-ink each time.
Adhere the large stamped white rectangle to the Rich Razzleberry rectangle and then to the card front.
Cut out the two flowers on the smaller white strip using Paper Snips.
Adhere the cut out flowers to the card front near the center of the bank of flowers using Stampin' Dimensionals. Let them overlap a little.
Use Paper Snips to cut one of the strings of Basic Rhinestone Jewels so it is 6 jewels long. Peel the string off the protective backing and adhere it below the word "thanks."