S
tamp Set: Autumn Leaves
Cardstock: Copper Clay, Very Vanilla, Crushed Curry, and All About Autumn 6” x 6” DSP
Ink: Crushed Curry and Copper Clay
Other: Stampin’ Cut and Emboss Machine, Fern 3D Embossing Folder, Autumn Leaves Dies, Stylish Shapes Dies, Copper & Natural Ribbon, Multipurpose Liquid Glue, Glue Dots, Stampin’ Dimensionals
1. The base of the card is Copper Clay cardstock cut at 5-1/2” x 8-1/2” and scored at 4-1/4” in the middle.
2. The Very Vanilla cardstock is the second layer and it is cut at 4” x 5-1/4” and inserted into the Fern 3D Embossing Folder and run through the Stampin’ Cut and Emboss Machine. Layer it onto the base front with Multipurpose Liquid Glue.
3. From the Designer Series Paper, you need to decide which part of the DSP you want to use to make a 3-3/4” x 4-1/2” scenery, so you’ll need to cut some off the top as well as the bottom and the left side. Then cut three panels at 1-1/4” each.
4. Layer these 3 DSP panels onto 3 panels of Crushed Curry cardstock that is cut at 3-7/8” x 1-5/8” each.
5. Now attach the left scene first to the Very Vanilla emboss cardstock, then the right and the middle one last all with Multipurpose Liquid Glue. They should have A border of Very Vanilla showing through.
6. Ink up the large leave with Crushed Curry on Very Vanilla cardstock and die-cut it out with the large leaf die that matches. Add Stampin’ Dimensionals to the back and attach to the upper left-hand side of the card.
7. Ink up the sentiment “I’m Thankful” on Very Vanilla cardstock and die-cut with the banner die from Stylish Shapes Dies. Add the sentiment with Glue Dots and Stampin’ Dimensionals across the leaf.
8. Tie a bow with the Copper Ribbon and attach with a Glue Dot below the banner.