P retty, wintery card using Stampin' Up! products including one you can earn for FREE during Sale-A-Bration 2019.
Project Recipe
Cut cardstock pieces to the following sizes using a Stampin' Trimmer:
- card from Pool Party Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Pacific Point Cardstock
- 3-7/8" x 5-1/8" from Whisper White Cardstock
- 3-1/4" square from Pacific Point Cardstock
- 2" x 3-1/4" from Pool Party Cardstock
As you are ready to stamp using the All Adorned Set, place the cardstock on the Stampin' Pierce Mat. Using the mat will help you get a cleaner image each time you stamp. Put a piece of paper (Grid Paper works great) on top of the Mat to protect it from ink.
Mount the larger, medallion with pointy arrows image from the All Adorned Set on Block D. Ink it up with the Pacific Point Ink Pad. Stamp it randomly all over the white rectangle. Remember to re-ink the stamp each time. Rotate the orientation and let some of the images go off the edges of the cardstock.
Mount the medium-sized, medallion with rounded edges image from the All Adorned Set on Block C. Ink it up with the Pool Party Ink Pad. Stamp it inside on of the previously stamped Pacific Point images. Repeat until you have stamped it inside all the previously stamped Pacific Point images, remembering to re-ink the stamp each time.
Adhere the stamped white layer to the large Pacific Point rectangle and then to the front of the Pool Party card.
Pick out the largest, open, filigree-edged, circle thinlit from the Eastern Medallions Thinlits and the smooth, circle framelit from the Layering Circles Framelits that cuts out a 2-15/16" diameter circle. Place the Pacific Point square on the Precision Base Plate on top of the Platform on the Big Shot. Place the filigree-edged, circle thinlit on top. Place the circle framelit on top so it is centered around the filigree-edged, circle thinlit. Place a Cutting Pad on top and run through the Big Shot a couple of times. Use the Die Brush or paper-piercing tool on the Take Your Pick to remove the pieces.
Adhere the medallion circle cut out to the front of the card so it is about 3/4" from the top, left, and right sides.
Mount the "You are pretty much the best ever" sentiment from the All Adorned Set on Block C. Ink it up with the Pacific Point Ink Pad. Stamp it near one end of the strip of Pool Party Cardstock, leaving room to punch it out.
Unlock the Pretty Label Punch. Holding the punch upside down so you can see the punching area, slide the stamped sentiment into the punch and get it centered in the punching area. Punch.
Cut a 6-1/2" piece of the Pool Party 3/8" Shimmer Ribbon.
Fold the ribbon in half. Adhere it to the back of the sentiment punch out in the center using a strip of Tear & Tape Adhesive. Make sure the folded end of the ribbon pokes out above the top of the sentiment punch out by about 1/2". Leave the protective backing on the adhesive in place. Trim the loose ends of the ribbon into angles.
Put Stampin' Dimensionals on the back of the sentiment punch out. Remove the protective backings from the Dimensionals and adhere the sentiment punch out (with ribbon attached) to the center of the Pacific Point medallion on the card front.
Use the mini spatula on the Take Your Pick to carefully peel up two small clear circle droplets and one large frosted circle droplet from a sheet of Frosted & Clear Epoxy Droplets making sure that you get the adhesive backings as well. Adhere them to the centers of three of the snowflakes on the card front.