C hristmas Card using the Wrapped in Plaid Suite Stampin' Up! 2019
Project Recipe
Shaded Spruce 5.5 x 8.5 Card Base
5-1/4 x 2 Wrapped in Plaid DSP
5-1/4 x 2-1/8 Crumb Cake
1 x 4 Whisper White Sentiment Piece
3 punched Trees, two from the DSP, one on Whisper White
2 inch Night of Navy punched circle
2-1/4 Cherry Cobbler punched starburst
8 inches Shaded Spruce/Gold Ribbon
Fold the card base in half.
Adhere the Plaid DSP to the top half of card leaving a 1/8 border at all three sides.
Run the Crumb Cake through the Corrugated embossing folder.
Adhere to the bottom half of the card again leaving 1/8 border at all three sides.
Stamp sentiment in Cherry Cobbler ink to the left side of the sentiment piece of Whisper White.
Adhere to the right centre of the card front lining it up with the DSP layer edge.
Adhere the Night of Navy circle to the Cherry Cobbler starburst.
Adhere these to the card front about 1/8 inch in from the edge of the DSP on left front of the card.
Using the Stamparatus, stamp the outline of the tree with Soft Suede and the leaves with Shaded Spruce onto Whisper White. Punch out with tree punch.
Punch out the tree image and the Cherry Cobbler polka dot pattern from the DSP using the tree punch.
Adhere the first DSP tree to the circle at the upper right lining the bottom branch so that it covers to the edge of the Corrugated and Plaid DSP.
Adhere the second tree to the upper left of the circle slightly lower than the first and taking care that it doesn't cover the sentiment.
Adhere the stamped tree at the bottom centre of the circle.
Tie the ribbon into a bow, trim the ends and adhere below the sentiment using glue dots.
Using the tree stamp, stamp the Whisper White insert and the envelop using Shaded Spruce, full strength and then again offset, without re-inking.