Project Recipe
Cutting & Scoring:
Cherry Cobbler: 8 1/2" x 5 1/2" scored at 4 1/4"
Evening Evergreen: 5 3/8" x 4 1/8", Scrap for die cutting
Basic White: 5 1/4" x 4", scrap for die cutting
Green DSP: 5 1/4" x 4"
Red DSP: Scrap for die cutting
Green with red and white DSP: Scrap for die cutting.
Stamping: Use Cherry Cobble ink and stamp the single banner on Basic White. Stamp the sentiment on the banner.
On the large Basic White layer stamp the pine bough in the bottom right corner and then restamp using second generation ink again. Glue this layer into the inside of the card.
Die Cutting: Cut the swirl frame out of the Evening Evergreen and the red DSP.
Die cut the banner/sentiment with the single banner die.
Use the pine needle branch die to cut the branch out of DSP.
Assembly:
Adhere the red DSP center from the frame die cut into the Evergreen frame die cut. I used scotch tape for this.
Using dimensionals attach the frame to the center of the green DSP.
Add the green DSP layer onto the Evergreen layer then attach all layers to the card base.
Finishing Touches:
Add Wink of Stella to the Pine Branches and adhere to the center of the frame.
Use dimensionals to attach the sentiment.
Roll a glue dot into a small ball and attach the small gold bow to the center of the sentiment.
Place the Festive Pearls around the pine branch.
Share your card with someone special!!