F un card to say welcome to the Team using Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Stampin' Trimmer:
- card from Daffodil Delight Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Grapefruit Grove Cardstock
- 3-7/8" x 5-1/8" of small Daffodil Delight plaid design from Gingham Gala 6" x 6" Designer Series Paper
- 2-1/4" x 3-1/2" from Grapefruit Grove Cardstock
- 2" x 3-1/4" from Whisper White Cardstock
- 1" x 4" from Whisper White Cardstock
Adhere the piece of Gingham Gala Designer Series Paper to the large Grapefruit Grove rectangle and then to the front of the Daffodil Delight card.
Mount the "welcome to the team!" sentiment from the Stamping Your Way To The Top Set on Block C. Ink it up with the Daffodil Delight Ink Pad. Stamp it slightly to the right of center on the large white rectangle.
Pick out the stitched rectangle framelit from the Rectangle Stitched Framelits that cuts out a 1-7/16" x 2-3/4" rectangle. Place the stamped sentiment white cardstock on the Cutting Pad on top of the Magnetic Platform on the Big Shot. Place the stitched rectangle framelit on top so the words are slightly closer to the right side. Place another Cutting Pad on top and run through the Big Shot.
Pick out the stitched rectangle framelit from the Rectangle Stitched Framelits that cuts out a 1-3/4" x 3-1/8" rectangle. Place the smaller rectangle of Grapefruit Grove Cardstock on the Cutting Pad on top of the Platform on the Big Shot. Place the stitched rectangle framelit on top. Place another Cutting Pad on top and run through the Big Shot.
Adhere the white sentiment rectangle cut out to the center of the Grapefruit Grove rectangle cut out. Then, adhere them to the front of the card so they are centered side to side and about 1" from the top edge.
Mount the envelope image from the Stamping Your Way To The Top Set on Block A. Ink it up with the Grapefruit Grove Ink Pad. Stamp it three times on the strip of white cardstock remembering to re-ink the stamp each time.
Use Paper Snips to cut out the envelope images by hand. Just cut the shadow off.
Use SNAIL to adhere two of the envelope cut outs to the left side of the matted sentiment rectangles so they overlap a bit and overlap the left edge of the rectangles.
Use a Stampin' Dimensional to adhere the third envelope cut out to the card front so it overlaps the other two envelopes along the bottom.
Cut an 8" piece of the Grapefruit Grove twine from the Nature's Twine.
Tie a small bow in the center of the twine. Trim the ends.
Use a Mini Glue Dot to adhere the bow to the front of the card so it is in the lower right corner of the matted sentiment rectangles.
Use the mini spatula on the Take Your Pick to carefully peel up three flower-shaped Grapefruit Grove sequins from a sheet of Gingham Gala Adhesive-Backed Sequins making sure that you get the adhesive backings as well. Adhere them randomly to the card front.