C
ard Measurements:
Just Jade cs card base - 8 1/2" x 5 1/2" scored 4 1/4"
Embossed Whisper White cs panel - 4" x 5 1/4"
Just Jade cs scrap - three die cut trees die cut with the Pine Woods Dies
Whisper White cs sentiment label - largest label die cut with Hippo & Friends Dies
Whisper White cs inside panel - 3 7/8" x 5 1/8"
cs = cardstock
Project Recipe
Start with a Just Jade cs card base. Cut a Whisper White cs panel and dry emboss it with the Evergreen Forest 3D embossing folder. Wrapped the embossed panel with a piece of Just Jade In Color ribbon using glue dots to secure the ends on the back of the panel and then glue the wrapped panel to the card base.
Die cut three (1 large & two smaller) Just Jade cs trees with the Pine Woods Dies and glue them to the right side of the front panel tucked under the ribbon. Die cut out a Whisper White cs label with the Hippo & Friends Dies. Stamp the sentiment from the Rooted in Nature stamp set in Just Jade ink on the Whisper White cs label.
Use Stampin' Dimensionals to attach the stamped label centered on the card front overlapping the wrapped ribbon. Add 2020-2022 In Color Enamel dots to the sentiment label. Tie a small bow with the Just Jade In Color ribbon and attach it with glue dots to the left of the sentiment label overlapping the wrapped ribbon.
Don't forget to add a Whisper White cs inside panel to write your message. I stamped the sentiment and trees from the In The Pines stamp set in Just Jade ink on the inside and back of the card to pull the theme through.