S pooky treat box using Stampin' Up! products.
Project Recipe
Cut cardstock, foil sheets, and designer paper pieces to the following sizes using a Paper Trimmer:
- 2-1/4" x 4-1/4" of black filigree pattern on white background design from Monster Bash Designer Series Paper
- 2-1/2" square from Silver Foil Sheets
- 2" square from Whisper White Cardstock
Fold a Coffin Treat Box base and lid along all score lines using the Bone Folder.
Use pieces of Tear & Tape Adhesive to hold the box together. Set aside.
Use pieces of Tear & Tape Adhesive to hold the lid together.
Place the piece of Monster Bash Designer Paper upside down on your work surface (in this case, the black filigree design face down).
Place the lid upside down in the middle of the piece of designer paper. Trace around the outside edges using a pencil.
Use Paper Snips to cut out the traced area just inside the pencil lines.
Use SNAIL Adhesive to adhere the cut out paper right side up (in this case, the black filigree design face up) to the top of the lid. Use Paper Snips to trim off any excess designer paper along the edges.
Mount the framed dracula image from the Spooktacular Bash Set on Block B. Ink it up with the StazOn Ink Pad. Stamp it in the center of the small white square.
Pick out the matching square die with pointy corners from the Ornate Frames Dies. Put it on top of the stamped framed dracula image on a platform on your cutting and embossing tool so the image is centered. Run through the tool.
One at a time, squeeze the lids of the ink pads to get ink in the lids. If needed, add ink to the lids using Ink Refills. One at a time, use the Blender Pen to pick up ink from the pad lids and color in the framed dracula image. Remember to stroke in one direction only or the cardstock will tear and pill up. Remember to scribble on Grid Paper in between colors until no more color is coming off the Blender Pen.
Use the following colors:
Purple Posy – for dracula's face, ears, and hands
Gorgeous Grape - for canvas behind dracula
Highland Heather - for frame
Pick out the square filigree frame die from the Ornate Frames Dies. Put the die on top of the Silver Foil Sheets square on a platform on your cutting and embossing tool. Run through the tool. Use the Take Your Pick Die Brush Tip and/or paper-piercing tool on the Take Your Pick to remove the pieces.
Adhere the colored framed dracula cut out to the center of the Silver Foil filigree frame using Tear & Tape Adhesive.
Adhere the framed, matted dracula image to the top of the lid so it is centered side to side and near the top using pieces of Tear & Tape Adhesive.
Cut a 3" piece of Purple 3/8" Tricolor Ribbon.
Tie a half knot in the center of the ribbon. Trim the ends.
Use a Mini Glue Dot to adhere the ribbon knot to the top of the lid at an angle in the lower left corner of the framed image.
Use the mini spatula on the Take Your Pick tool to pick up a raven shape from a sheet of Monster Bash Enamel Shapes being sure to get the adhesive as well. Adhere it to the front of the lid on the upper right side of the framed image.