C ute new baby card using Stampin' Up! products.
Project Recipe
Cut card stock pieces to the following sizes using a Stampin' Trimmer:
- card from Real Red Card Stock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Dapper Denim Card Stock
- 2-1/4" x 2-3/4" from Whisper White Card Stock
- 1" x 1-1/2" from Whisper White Card Stock
- scrap of Real Red Card Stock at least 1-1/4" wide
Place the Dapper Denim rectangle into the Lucky Stars Embossing Folder. Place the folder with the card stock inside on top of a Cutting Pad on your Big Shot Platform at the lowest possible setting. Place another Cutting Pad on top of the folder and run through the Big Shot.
Adhere the dry embossed rectangle to the front of the Real Red card.
Mount the onesie image from the Something for Baby Set on Block D. Ink it up with the Real Red Ink Pad. Stamp it in the center of the large white rectangle.
Mount the tie image on Block B. Ink it up with the Dapper Denim Ink Pad. Stamp it in the center of the smaller white rectangle.
Pick out the onesie framelit and the tie framelit from the Baby's First Framelits. Place the stamped images on the Cutting Pad on top of the Magnetic Platform on the Big Shot. Place the framelits on top so they are centered over the stamped images. Place another Cutting Pad on top and run through the Big Shot.
Adhere the tie to the onesie image.
Put Stampin' Dimensionals on the back of the onesie image up and down both sides and fairly closely spaced.
Cut a 5" piece of Real Red 3/8" Stitched Satin Ribbon.
Fold the ribbon in half lengthwise on one end. Cut at an angle towards the fold. Unfold the ribbon and you should have a notched end. Repeat on the other side. You should have a piece of ribbon about 4" long with notches on the ends.
Lay the ribbon across the center of the card front.
Remove the protective backings from the Dimensionals on the back of the onesie and adhere it in place in the center of the card front. It should hold the ribbon in place as well.
Unlock the Confetti Hearts Border Punch. Slide the scrap of Real Red Card Stock inside so it is flush against the back edge. Punch.
Pick out 4 small punched out hearts. Adhere them to the card front as shown using the Fine-Tip Glue Pen.
Pick out 3 gold circle sequins from the Metallics Sequin Assortment. Adhere them to the card front as shown using Mini Glue Dots.