S
tamp Set: So Very Merry, Trucking Along
Cardstock: Real Red, Basic White, Basic Black, Vellum, Gold Foil
Ink: Tuxedo Black Memento, Black Stazon
Stampin’ Blends: Azure Afternoon, Smoky Slate, Real Red
Other: Stampin’ Cut and Emboss Machine, Painted Texture 3D Embossing Folder, Stylish Shapes Dies, Nested Essentials Dies, Wink of Stella, Paper Snips, Multipurpose Liquid Glue, Silicone Craft Sheet, Small Blending Brush, Stampin’ Dimensionals, Festive Pearls
1. The base of the card is Real Red cardstock cut at 5-1/2” x 8-1/2” and scored at 4-1/4” in the middle.
2. The second layer is Basic White cardstock cut at 4” x 5-1/4” and inserted into the Painted Texture 3D Embossing Folder and run through the Stampin’ Cut and Emboss Machine.
3. Die-cut the 2nd largest Nested Essentials Dies with Basic Black cardstock. Cut in half, and adhere to each side with Multipurpose Liquid Glue.
4. Ink up the Santa stamp with Black Stazon and stamp on the Vellum. Immediately, clean off the stamp to remove the permanent ink before it dries.
5. Turn the Vellum over to color on the back with the Stampin’ Blends. Turn back over and add Wink of Stella to his beard and white parts on his cap. With Paper Snips, trim it out the circle.
6. Use the Silicone Craft Sheet to put Multipurpose Liquid Glue and use the Small Blending Brush to add the glue to the back of the Santa Vellum and then adhered it to the Gold Foil circle die-cut with the Stylish Shapes 2nd to the largest circle die.
7. Add Stampin’ Dimensionals to the back and adhere to the center of the card.
8. Ink up the sentiment “Wishing You a Festive Christmas” from the Trucking Along Stamp with Tuxedo Black Memento on Basic White cardstock. Die-cut with the 2nd largest banner die. Die-cut a Real Red banner die. Cut it in half and add to the back of the Basic White Banner at each end with Multipurpose Liquid Glue. Then add Stampin’ Dimensionals and adhere to the bottom of the card.