H eat Embossed cherry blossom tree with bicycle
Project Recipe
Use your Stampin' Trimmer to:
Cut Blushing Bride Cardstock to 5 1/2 x 8 1/2 for side opening or 11x 4 1/4 for bottom opening. This will be the card base.
Cut Whisper White Cardstock to 5 x 3 3/4, this is the card front.
Stamp these on the Whisper White card front.
Ink the grass swoosh stamp with Old Olive and stamp in the lower left corner.
Ink the tree trunk stamp with Soft Suede and stamp just barely overlapping the top of the grass.
Ink bicycle wheels stamp with Early Espresso and stamp to the right of the tree.
Ink the bicycle frame with the Olive Olive and stamp into the bicycle.
Use the Old Olive to ink the sentiment and stamp it in the upper right just above the tree.
Use Blushing Bride to ink the blossom stamp and stamp it over the branches.
Use a Versa Mark pad to ink the blossom stamp then stamp over the Blushing Bride impression.
Sprinkle White Embossing Powder over the Versamark imprint. Then gentle shake the excess back into the container.
Use the Heat Tool to melt the embossing powder into a glossy finish.
Use the Bow Builder Punch with your favorite DSP to make two sets of punch outs.
Use your bone folder to curve the two bow loop pieces.
Then use glue dots to adhere the bow loop end pieces.
Wrap the center piece around the bow loops.
Then add the bow ends with glue dots to the back of the loops.
Use Stampin' Dimensionals to attach the bow to the card.
Use Fast Fuse and attach the Whisper White card front to the Blushing Bride base.