A dorable treat boxes perfect for Valentine's Day. Uses Stampin' Up! products.
Project Recipe
To make one box, cut card stock and designer paper pieces to the following sizes using a Stampin' Trimmer:
- 6" square from Whisper White Card Stock
- 6" square piece of Sending Love Designer Series Paper Stack in pattern of your choice, no cutting needed as the paper is already 6" square
- two 2-1/4" squares from Real Red Card Stock
- scrap of Whisper White Card Stock at least 1-1/4" square
Put SNAIL Adhesive all along the edges and in the middle of the large white square of card stock. Carefully adhere the designer paper square to the white card stock.
Follow the directions printed on the Gift Box Punch Board to punch and score the card stock/designer paper square. Fold the box together. Insert a treat inside the box before closing up the last two flaps using the punched hooks.
Pick out the Love Notes Framelit that cuts out a small four-sided petal card. Place one of the Real Red squares on a Cutting Pad on top of the Platform on your Big Shot. Place the Love Notes Framelit on top of the card stock so it is centered. Place another Cutting Pad on top and run through the Big Shot. Repeat with the second Real Red square.
Fold up the petals on the red cut outs a little bit.
Put a small piece of Tear & Tape Adhesive across the back of the center square on one of the red petal card cut outs. Adhere it on top of the other petal card cut out at a slight angle.
Use Paper Snips to cut a tiny piece of the edge of a sheet of Stampin' Dimensionals. Adhere the tiny dimensional piece to one of the hooks that holds your box closed. Cut another tiny piece of dimensional and adhere it as close as you can to the other hook, making sure that both pieces of dimensional are on the same flap of the box.
Peel off the protective backing from the dimensional pieces and adhere the red petal card flower to the dimensionals.
Choose one of the smaller images from the Sealed with Love Photopolymer Stamp Set. Mount it on Block A. Ink it up with the Real Red Ink Pad. Stamp it on the scrap of Whisper White Card Stock.
Pick out the Love Notes Framelit that cuts out a scalloped edge square. Place the small image you just stamped on a Cutting Pad on top of the Magnetic Platform on your Big Shot. Place the scalloped edge square framelit over the image so the image is centered. Place another Cutting Pad on top and run through the Big Shot.
Adhere aStampin' Dimensional to the back of the square cut out. Adhere loops of Silver Metallic Thread to the dimensional.
Adhere the square cut out with metallic thread attached to the center of the red petal card flower.