H and decorated gift/treat bag using Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer:
- 1-3/4" x 3-3/4" of lines of green sweater design from Beary Christmas 12" x 12" Designer Series Paper, cut so the lines are horizontal on the horizontal rectangle
- 1-1/2" x 3-1/4" from Basic White Cardstock
- 3 mostly green presents cut from presents design from Beary Christmas 12" x 12" Designer Series Paper using Paper Snips Scissors
Pick out a Pebbled Path bag from the 2023-2025 In Color Treat Bags and place it on some Grid Paper to protect your work surface.
Use a ruler to draw lines vertically down the bag with the brush tip of the Mossy Meadow Stampin' Write Marker.
Use a ruler to draw lines horizontally across the bag with the brush tip of the Old Olive Stampin' Write Marker.
If you haven't already done so, cut out 3 mostly green presents from the sheet of presents Beary Christmas Designer Series Paper using Paper Snips.
Adhere the presents in the lower right corner of the bag so they overlap slightly as shown using Stampin' Seal and Stampin' Dimensionals.
Pick out the rounded top tag die from the Tailor Made Tags Dies that cuts out a tag that is 3-3/8" long. Put it on top of the green sweater pattern Beary Christmas Designer Paper rectangle on a platform on your Stampin' Cut & Emboss Machine. Run through the machine.
As you are ready to stamp using the Rocking Horse Set, place the cardstock on the Stampin' Pierce Mat. Using the mat will help you get a cleaner image each time you stamp.
Mount the "sending Christmas joy" sentiment from the Rocking Horse Set on Block H. Ink it up with the Old Olive Ink Pad. Stamp it in the center of the horizontal white strip.
Pick out the rounded top tag die from the Tailor Made Tags Dies that cuts out a tag that is 2-3/4" long. Put it on top of the stamped sentiment on a platform on your Stampin' Cut & Emboss Machine so the sentiment is centered and the top of the tag is on the left side. Run through the machine.
Adhere the sentiment tag cut out to the top of the designer paper tag cut out so they are slightly off set as shown and the holes in the tops of the tags line up.
Cut a 6" piece of the Pebbled Path jute trim from the 2023-2025 In Color Jute Trim.
Fold the jute trim in half. Poke the folded end of the jute trim through the holes in the tops of the tags from the back and pull it through a bit. Poke the loose ends of the jute trim through the loop and tighten. Trim the ends.
Adhere the layered tags with jute trim attached to the upper left side of the bag front a shown.
Fill the bag with treats. Fold the top of the bag over to the back side and secure in place with a bit of washi tape or cello tape.