S oft and pretty thank you card using Stampin' Up! products.
Project Recipe
Cut cardstock and designer paper pieces to the following sizes using a Paper Trimmer:
- card from Petal Pink Cardstock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Gray Granite Cardstock
- 3-7/8" x 5-1/8" lightly mottled pink design from Peony Garden Designer Series Paper
- 3" x 3-7/8" from Gray Granite Cardstock
- 1-3/4" x 3" from Petal Pink Cardstock
Place the piece of Peony Garden Designer Paper on some Grid Paper to protect your work surface. Mount the large, single peony with no leaves image from the Prized Peony Set on Block D. Ink it up with the Gray Granite Ink Pad. Stamp it in the lower right corner of the designer paper so some of the image goes off the paper in the right corner.
Adhere the stamped designer paper to the large Gray Granite rectangle and then to the front of the Petal Pink card.
Pick out the long scalloped edge die from the Peony Dies. Put it on top of one short side of the remaining Gray Granite rectangle on a platform on your cutting and embossing tool so the bumps along the bottom of the die are about 1/8" from the bottom of the cardstock. Run through the tool.
Mount the "love & thanks..." sentiment from the Prized Peony Set on Block G. Ink it up with the Gray Granite Ink Pad. Stamp it in the center of the Petal Pink rectangle.
Pick out the label die that cuts out a label that is 1-3/16" x 2-1/4" from the Stitched Nested Labels Dies. Put it on top of the stamped sentiment on a platform on your cutting and embossing tool so the sentiment is centered. Run through the tool.
Adhere the sentiment label cut out to the center of a Square Vellum Doily. Then, put more adhesive on the back of the doily where it is hidden by the sentiment label cut out and adhere the doily to the top of the die cut Gray Granite rectangle so the bumps are on the bottom of the rectangle.
Cut a 3-1/2" piece of the Gray Granite 1/4" Shimmer Ribbon.
Lay the ribbon across the Gray Granite rectangle just below the bottom of the doily. Flip the rectangle over and fold the ends of the ribbon over. Adhere the ends of the ribbon in place with pieces of Tear & Tape Adhesive.
Remove the protective backing from the Tear & Tape strips and add Stampin' Seal to the back of the Gray Granite rectangle. Adhere it to the front of the card so the top, left, and right edges are about 5/8" from the edges.
Cut another 3-1/2" piece of Gray Granite 1/4" Shimmer Ribbon.
Slide one end of the ribbon under the ribbon already on the card front so it is centered under the doily. Tie it in place using a half knot. Trim the ends.
Use the mini spatula on the Take Your Pick to carefully peel up 2 small Petal Pink gems from a sheet of Elegant Faceted Gems making sure that you get the adhesive backings as well. Adhere them to the centers of the flower bursts at the top and bottom of the center of the doily (above and below the sentiment label cut out).