Sandra Mastello
https://www.violetvspurplepapercrafts.com sandra@violetvspurplepapercrafts.com |
Wood Textures Herringbone Card |
|
F
or this card you will need to pre-cut the following items:
*Very Vanilla Thick cardstock - A5 folded in half (14.8x21cm) for the card base
*Early Espresso Cardstock 14.3x10cm
*Very Vanilla 13.8x9.5cm
*Very Vanilla Banner 6x2.5cm
*Designer Series Paper Strips 1.5cm wide
*Scrap of Ribbon
|
Take your Designer Paper and if you haven't already done so create 1.5cm strips from multiple coloured sheets.
Take your small piece of very vanilla cardstock add some glue to about 1/4 of it.
Lay your first strip onto the glued area of the cardstock, use this strip to line up the ends of your next strips against, leaving the ends to hang over the cardstock.
Once you have the first section done turn the cardstock over and use some scissors to trim the strips to the size of the card stock.
Continue this process around the card.
Banner is created by inserting a 2.5cm strip of cardstock into the center of the everyday label punch. Once made stamp with greeting.
Lastly adhere all your layers together, add a piece of scrap ribbon and then use dimensionals to pop the greeting up.