Rachel Brumley
http://www.stampwithrachel.com rachelbrumley@cox.net |
Santa's Sleigh |
|
C
ard Measurements
1. Base Card - Whisper White Card Stock (4 1/4" x 5 1/2")
2. Deer - Whisper White Card Stock (2" x 3")
3. Greetings - Whisper White Card Stock (2 1/2" x 2 1/2")
4. Top - Be Merry DSP - ( 2 3/8" x 5 3/8")
5. Bottom - Be Merry DSP (1 3/4" x 5 3/8")
|
|
|
Take card base and fold in half using the bone folder for a sharp crease. Set aside.
Adhere the two pieces of DSP so that red pattern is on the top and the green pattern on the bottom. Use scotch tape on the back side to get them together. Attached ribbon with Tear & Tape Adhesive. Adhere to base card with Multipurpose Liquid Glue
Stamp greeting with Cherry Cobbler ink onto 2 1/2" x 2 1/2" piece of Whisper White Card Stock.
Stamp leaves with Garden Green Ink. Run through Big Shot using the circle from Stitched Shapes Thinlits. Trim about 1/4" off bottom of circle (see photo). Adhere to base card with liquid multipurpose glue just above the ribbon (see photo for placement)
Take 2 x 3 Whisper White Card Stock and run the Embossing Body all over the surface. Stamp the deer image with Versamark Ink. Sprinkle Gold Embossing Powder and set with the Heat Tool. Run the image through the Big Shot using the deer thinlits from the Santa's Sleigh Thinlits Dies.
Add to front of card using Stampin' Dimensionals (see photo for placement)
Add 3 gold sequins to ribbon just below the greetings. (see photo for placement)