Ribbon slider card
Card stock sizes
Card base - 5 1/2“ x 4 1/4“-Soft Seafoam
First layer-4“ x 11“-Grapefruit Grove card stock.
Slider inside-3“ x 5“ -whisper white
Score the first layer in half and then cut off a quarter inch on the open side .
Lay down tear tape on the top and the bottom as close to the edges you could get them . Close the card stock so that you have a pocket .
Run this through the big shot using the lace embossing folder .
Place the whisper white piece of card stock that is 3“ x 5“ on the inside sliding it completely in.
Take a hole punch and punch a hole 1 inch in and in the center .
Take the whisper white inside of the card out and turn it around the opposite way- Sliding it back into the pocket and aligning the holes . Apply a piece of Post-it note to stabilize it
Take 24 inches of very thin ribbon and slide this through the hole that you punched . Wrap the ribbon clear around to the top of the whisper white card stock and tie a bow .
Decorate the outside of the card and the inside slider with stamps and ink