Michele Reynolds
http://inspirationink.typepad.com/inspiration-ink/ michelerey@aol.com |
Reverse Words Beer Cheer |
F un birthday card using Stampin' Up! products.
|
|
|
Cut card stock and designer paper pieces to the following sizes using a Stampin' Trimmer:
- card from Delightful Dijon Card Stock at 5-1/2" x 8-1/2" and scored at 4-1/4"
- 4" x 5-1/4" from Whisper White Card Stock
- 1-3/4" x 2-1/2" from Whisper White Card Stock
- 3/4" x 5-1/4" of closely spaced yellow honeycomb shapes on lighter yellow design of paper from Moroccan Designer Series Paper
Mount cheers sentiment from Reverse Words Set on Block I. Ink it up with Delightful Dijon Ink Pad. Stamp it slightly to the left of center in the middle of the large white rectangle.
Adhere the strip of Moroccan Designer Series Paper across the bottom of the stamped white rectangle.
Cut three 6" pieces of Basic Black Baker's Twine. If there are kinks in the twine from being wrapped around the cardboard in the package, you can remove the kinks by pinching a cotton ball soaked with rubbing alcohol or a baby wipe around one end of the twine and pulling it through. Allow the twine to dry before adhering it to your project.
Lay the three twine pieces across the designer paper/white rectangle so it covers the seam. Flip the rectangle over and fold the ends of the twine over. Adhere them in place with pieces of Tear & Tape Adhesive across the ends.
Adhere the designer paper/white rectangle to the front of the Delightful Dijon card.
Cut a 30" piece of Basic Black Baker's Twine. Remove kinks if necessary. Double the twine on itself and then tie it to the left side of the twine on the card front in a bow. Trim the ends.
Mount the beer mug image from the Mixed Drinks Stamp Set on Block D. Ink it up with the Basic Black Archival Ink Pad. Stamp it in the center of the smaller white rectangle.
Mount the matching solid interior piece for the beer mug on Block B. Ink it up with the Delightful Dijon Ink Pad. Stamp it inside the bottom of the beer mug image. Make sure that the yellow color is below the bit of foam dripping down the side of the mug.
Cut out the mug by hand using Paper Snips.
Adhere the mug to the card front on the right side of the cheers sentiment at a slight angle using Stampin' Dimensionals.