Andrea Sharp
http://andrea-sharp.stampinup.net andrea.sharp@gmail.com |
No Bones About It SAS Card |
A
waterfall card featuring some super-cute dinosaurs.
Measurements:
Early Espresso - 5 1/2" x 4 1/4", 1" x 4 1/4", 2" x 2" (cut 4)
Old Olive - 5 1/4" x 4", 2" x 9" scored @ 2", 2 3/4", 3 1/2" & 4 1/4"
Whisper White - 1 3/4" x 1 3/4" (cut 4)
Island Indigo ribbon - 4"
|
|
|
Stamp the 4" x 5 1/4" Old Olive layer using the Dots for Days stamp with Old Olive ink.
Adhere the stamped Old Olive cardstock to the Early Espresso card base.
Punch a pull notch in the bottom-center of the Old Olive/Early Espresso card using the 1 1/4" Circle punch.
Stamp the T-Rex image on a Whisper White square using Pumpkin Pie ink.
Stamp the Stegosaurus image on a Whisper White square using Island Indigo ink.
Stamp the Triceratops image on a Whisper White square using Old Olive ink.
Stamp the Brontosaurus image on a Whisper White square using Crushed Curry ink.
Adhere the four stamped dinosaur pieces to the Early Espresso mats.
Stamp the "RAWR!" greeting in Early Espresso ink just below the 4 1/4" score line on the unscored side of the 2" x 9" Old Olive cardstock.
Attach the 1" x 4 1/4" Early Espresso strip about 1 1/4" up from the bottom of the Old Olive/Early Espresso card.
IMPORTANT: Make sure to only put adhesive on the side edges - the middle must NOT be attached.
Fold the four score lines on the Old Olive strip all in the same direction; the stamped greeting will be on the inside.
Adhere the top of the Brontosaurus panel just below the 2" score line on the Old Olive strip.
Adhere the top of the Triceratops panel just below the 2 3/4" score line on the Old Olive strip.
Adhere the top of the Stegosaurus panel just below the 3 1/2" score line on the Old Olive strip.
Adhere the top of the T-Rex panel just below the 4 1/4" score line on the Old Olive strip.
Open the Old Olive strip and slide the section with the greeting under the 1" Early Espresso strip so that it is centered on the card and the bottom extends into the punched half circle.
Place ~1 1/2" Tear & Tape adhesive across the bottom of the Early Espresso strip. Peel off the backing and lay the Old Olive strip on top of it. The Tear & Tape adhesive will be under the lower part of the Brontosaurus panel.
Pierce 1 hole on each end of the Early Espresso strip. Place a Candy Dot brad base and put two different colors of Candy Dots over the brad.
Staple the Island Indigo ribbon to the bottom of the Old Olive strip to create the pull tab. Trim the ends of the ribbon if desired.