Jo-Anne Rogers
http://www.designwithjo.ca jo@designwithjo.ca |
Merry Christmas Jingle Bell Tree Tag |
|
A simple and quick tag to dress up your Christmas gift giving this year.
|
Cuttin' It Up!
* Cherry Cobbler - 2 1/2" x 4"
* DSP - scraps at least 2 1/2" x 2"
* Whisper White - scraps at least 1 1/2" x 3"
* Shaded Spruce - scraps at least 1 1/4" square
* Shaded Srpuce 3/8" Gold Striped Ribbon - 6"
Let's Make It
Clip off the top right hand side on a diagonal to make a "tag" edge. Pick up what you just cut off and place it on the back top left side, matching up the square corners. Cut the left side in alignment.
Emboss Cherry Cobbler with the Stylish Scroll Embossing Folder.
Stamp greeting on scrap of Whisper White with Shaded Spruce ink. Punch out with Timeless Label punch.
Glue to the top right hand side of the tag extending to the right.
Punch out one tree with the Pine Tree punch from the Wrapped in Plaid DSP.
Add to bottom left of tag with two dimensionals.
Punch out one 1" circle from Shaded Spruce cardstock.
Fold in half. Add liquid glue to inside and place over the top middle of the tag. Hold in place until it has set.
Use Crop-a-dile to punch a hole in the top (TIP: use the larger hole.
Fold ribbon in half and insert cut ends through the hole from the back about 1/3 of the length. Thread jingle bell onto one end of the ribbon. TIP: If the ribbon is cut in a diagonal it makes it easier.
Pull up the folded part of the ribbon at the back and open the loop. Insert the two ends through and tighten it up. TIP: Carefully pull on the ends so you do not rip the paper.