Cheryl Charland
http://www.homestylestamper.com ckcharland@charter.net |
Copper on the Side |
|
I cased this card from Pinterest with a few tweaks of my own. I'm in LOVE with the Brightly Gleaming DSP and Pretty Peacock cardstock.
|
|
Dimensions:
Pretty Peacock 8 1/2 x 5 1/2, scored at half
and 5 1/4 x 4
Brightly Gleaming DSP 4 x 2 1/2
Copper Foil 1/2 x 2, two pieces
Very Vanilla 1/2 x 3 and 4 x 5
Emboss the Pretty Peacock with the Hammered Metal 3D Embossing Folder. Adhere to the card front with Tear & Tape.
Adhere the two pieces of copper foil on the short ends of the DSP. I would use either Washi Tape or Fine Tip Glue.
With Tear & Tape, adhere to the card front.
On another piece of Pretty Peacock, stamp an ornament with Versamark and heat set the Copper Embossing Powder. Punch out with the coordinating punch.
Find the stitched oval die that is just a little bit larger than the ornament. Cut out and adhere to the card front.
On the strip of Very Vanilla, stamp the sentiment from the Itty Bitty Stamp Set in Pretty Peacock. Cut the banner ends with the paper snips.
Add the ornament and sentiment to the card front with dimensionals.
Stamp a sentiment on the remaining piece of Very Vanilla and adhere to the inside of the card.