S weet card using the Botanical Gardens Suite. Perfect for male or female. Use the Fern Leaf as a stencil include the sponged piece in your project!
Cut your Smoky Slate Cardstock to 21cm x 10.5cm. Score at 10.5cm, fold and burnish.
Using Mint Macaron stamp the leaf stamp from Timeless Textures in the top right corner and bottom left corner. Then stamp the dotty texture stamp to the left and to the right of the leafy stamp along the edge of the card.
Using scrap pieces of Pear Pizzazz Cardstock cut out two feather like leaves and one fern leaf with the Botanical Builder framelits and Big Shot machine - use the Precision Plate for the fern leaf to give it a good clean cut. Remove from Framelit with Die Brush.
Stamp Leaf details on Feather Leaf and Dauber Edges in Old Olive Ink.
Cut your White Corrugated cardstock to 7.5cm x 7.5cm.
Lay your fern leaf die cut diagonally on the corrugated piece. Carefullly dauber Mint Macaron over the diecut to give a 'fossil like' look on your card.
Position one feather like leaf up the centre of your 'fossil' allowing some white are to see the stencilled leaf and adhere flat.
Position your fern like leaf going up the right hand side and adhere with fine tip glue.
Position last leaf off to the left and adhere with dimensionals. (refer to picture of card for leaf positioning)
On your Whisper White stamp the ribbon banner in Smoky Slate and friend in Mint Macaron. Cut out banner.
Adhere this piece over the base of your leaves with a dimensional at each end.
Adhere your White Corrugated layer to your base card with Dimensionals
Decorate your card with White Perfect Accents and the Mint Macaron Enamel Dots
Clean Stamps & Pack Away =0)