Stephanie Flath
http://www.stephanieflath.stampinup.net stephanieflath@gmail.com |
Bethlehem Votive Candle Holder |
|
|
DSP & Adhesive Sheets: 5 1/2" x 2" and 1" x 2", Ribbon: 18"
Remove the backing from the adhesive sheet and apply the sheet to the back of the DSP. Do this for both sizes. (FOR CLASS, the smaller pc is done for you.)
Run both pcs DSP through Big Shot--adhesive sheet side down--with both sets of building thinlits. The large pc goes with the [3 palm trees] thinlit. The small one gets lined up ton include only the farthest left building and tree of the [2 palm trees] thinlit. (FOR CLASS, there's a post-it note marking the 2nd thinlit.)
Use Big Shot Die Brush and/or Paper Piercing Tool to remove DSP from thinlit AND remove all little windows from the thinlit for the next person.
Remove adhesive sheet backing from the larger pc and starting from the center, press the die cut onto and around the candle holder at the bottom. You'll have to work to keep the bottom lined up, and you may end up with a few wrinkles at the bottom in doing so.
Repeat step 5 for the small piece--filling in the gap from the larger one.
Wrap the bottom with the silver ribbon and tie a bow and trim the ends.