Thick Basic White cs card base - 11" x 4 1/4" scored at 4 1/4".
Embossed Basic White cs panel layer - 5 3/8" x 4 1/8".
Pattern Party DSP panel - 5" x 3 3/4" plus two 1/2" x 3 3/4" strips.
Basic White cs stitched scalloped rectangle - (2 1/2) die cut with the Scalloped Contours dies.
Black Glitter paper beak & feet - punched with the Penguin Builder Punch & the Turtle Punch.
Black & White Gingham ribbon
DSP = Designer Series Paper
cs = cardstock
Start with a Thick Basic White cs card base. Cut a Basic White cs panel layer and a Pattern Party DSP panel. Dry emboss the Basic White cs panel layer with the Painted Texture 3D embossing folder. Glue the DSP panel to the embossed panel layer and wrap the panels with Black & White Gingham ribbon using Stampin' Seal to secure the ends to the back of the panel. Glue the wrapped panels to the card base.
Die cut a Basic White cs stitched scalloped rectangle with the Scalloped Contours dies. Stamp the sentiment (slightly bend the photopolymer stamp to fit) from the Penguin Place in Memento Black ink on the top of the stitched scalloped rectangle. Stamp the penguin from the Penguin Place stamp set in Memento Black ink centered toward the bottom of the stitched scalloped rectangle. Add Wink of Stella to the penguin body. Punch out a Black Glitter paper beak with the Turtle punch and Black Glitter paper feet with the Penguin Builder punch. Use glue dots to add the beak & feet to the penguin. Use Black Stampin' Dimensionals to add the stitched scalloped rectangle to the card front overlapping the wrapped ribbon.
Tie a small bow with the Black & White Gingham ribbon and use glue dots to attach it to the left side of the stitched scalloped rectangle. Add Opal Rounds to the card front for extra sparkle.
I stamped the sentiment & penguin from the Penguin Place stamp set in Memento Black ink. I also added a strip of DSP to the inside and back of the card to pull the theme through.